Installation Guide
This luminaire is designed for outdoor applications and must adhere to 25°C (77°F)
maximum ambient temperature limitation.
Make all electrical connections in accordance with the National Electric Code and any
applicable local code requirements.
See Base instructions for proper installation instructions.
Turn power o before servicing
see instructions
Follow installation instructions
1. Place unit on 3” diameter x 3” long tenon.
2. Torque set screws to 10-12 ft-lbs.
1. Remove globe by rotating counter-
clockwise approximately 90° and raising
o locking ring (see Figure 1)
2. Install lamp (see Lamp Section).
3. Access to optional internal louver/shield-
ing is available with globe removed. Orient
shielding such that light is blocked in
direction intended.
4. Replace globe by lowering into locking
ring and rotating 90° clockwise.
5. Verify that orientation of globe is correct.
For proper orientation, see “Street/house
side” label on globes so equipped. Orien-
tation of the globe may be changed by
loosening tenon set screws and rotating
in desired direction. Retighten set screws.
Wear safety glasses and gloves during
installation and servicing
Allow lamp/xture to cool before handling
Lamp maintenance may be performed in one of three ways.
1. The complete globe and/or globe assembly may be removed by following
instruction given in GLOBE REMOVAL/INSTALLATION section (see Figure 1).
2. For hinged top globe assembly the lamp may be accessed by opening the top
portion of the globe in one of the following manners:
a. Disengage the clip by pulling it away from globe ring and rotate the top
upward (see Figure 2).
To close, rotate top downward and engage clip.
b. Thumb screw securing the lid should be rotated counter clockwise until it
disengages then rotate top upward (see Figure 3). To close rotate to
downward and secure thumb screw by rotating clockwise until tight.
g
GE
Lighting Solutions
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered suciently for the purchaser’s purposes, the matter should be referred to
GE Lighting Solutions.