Installation Guide

Installation Instructions
GT1
TM
LED Pedestrian 16x18’’ Incandescent Look
Signal Modules / PS7-CFF1-46A-J & PS7-CFF1-26A-J
Full Hand/Person Overlay/Countdown
Installation Steps:
1. Verify input voltage is within specified range on the back of the LED signal module before
installation. Failure to do so will cause lamp to fail.
2. Open front cover of (customer supplied) traffic signal housing.
3. Connect the wires to the appropriate terminal block within customer supplied signal housing.
(Orange wire (+ for Hand), Blue Wire (+ for Person) and White wire (for the neutral).
4. Close front cover of (customer supplied) traffic signal housing ensuring that the module gasket is
tight within the housing.
…Page 2
Back of 16 x 18 inch Pedestrian Module
Risk of Electric Shock
Install unit in enclosure tested to
be suitable for wet locations only.
Voltage Rating
Blue Wire
White Wire
Orange Wire
Countdown Option
Jumpers
(See next page)
16 x 18 inch Overlay / Countdown
Prepare Electrical Wiring
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Electrical Requirements
 Do not use in wet locations
 Follow all National Electric Codes
(NEC) and local codes.