Get installation instructions

Table Of Contents

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS L

Are these the right instructions for your model? Follow the Installation Instructions indicated by

the label on the back of the refrigerator— or

SRQPNML

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

•

CAUTION – Unplug the

Refrigerator. To eliminate the danger of

electric shock during installation, you

must unplug the refrigerator from its

electrical outlet.

Flat blade and Phillips

screwdrivers

Pliers

TOOLS YOU WILL NEED

Sharp knife

REMOVE ICE CUBE TRAY SHELF

• Remove the two screws securing the ice cube tray

to the side wall of the freezer. Remove the tray.

• Replace the screws but do not screw them all the

way in. The screw heads should extend about

1/2″ (13 mm) from the side wall of the freezer.

1/4″ Nutdriver or adjustable wrench

Remove

plug

INSTALL FILL TUBE EXTENSION

• Cut the fill tube extension (8)

to the length (refer to the

template on page 42) with a

sharp knife or a single-edge razor

blade and slide it onto the fill tube

against the stop.

PREPARE FOR INSTALLATION

• Remove and discard the large white plug from

the rear freezer wall.

• Remove the outlet cover with a flat-blade

screwdriver.