Specification Sheet

ManualsBrandsGE ManualsAppliancesWhite Laundry Center with 2.3 cu. ft. Washer and 4.4 cu. ft. 240-Volt Vented Electric Dryer

GUD24ESSM/24GSSM

Unitized Spacemaker

2.3 DOE Cu. Ft. Stainless Steel Washer and 4.4 Cu. Ft. Dryer

Listed by

Underwriters

Laboratories

For answers to your Monogram, GE Café

™

Series, GE Profile

™

Series or

GE Appliances product questions, visit our website at geappliances.com

or call GE Answer Center

Service, 800.626.2000.

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

Specification Revised 11/17

For complete information, see installation instructions packed with

your dryer.

DUCTING MATERIALS: This dryer MUST be vented with

4" diameter all rigid metal exhaust duct.

EXHAUST LENGTH CALCULATION:

1. Determine the number of 90° turns needed for your installation. If

you exhaust to the side or bottom of dryer, add one turn.

2. The maximum length of 4" rigid (aluminum or galvanized) duct

which can be tolerated is shown in the table.

For every extra 90° elbow, reduce the allowable vent system length

by 10 ft. Two 45° elbows will be treated like one 90° elbow. For the

side exhaust installations, add one 90° elbow to the chart. The total

vent system length includes all the straight portions and elbows of the

system (transition duct included).

Dryers must be exhausted to the outside.

CAUTION: For personal safety do not terminate exhaust into a

chimney, under any enclosed house floor (crawl space), or into an

attic, since the accumulated lint could create a fire hazard or moisture

could cause damage. Never terminate the exhaust into a common duct

or plenum with a kitchen exhaust, since the combination of lint and

grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent

back drafts, bird nesting, etc. The wall cap must also be located at

least 12" above the ground or any other obstruction with the opening

pointed down.

GUD24 DRYER EXHAUST LENGTH*

4" DIA.

2-1/2"

RECOMMENDED MAXIMUM LENGTH

Exhaust HoodTypes

Recommended

No. of 90º

Elbows

Rigid

Metal

Rigid

Metal

43 Feet

33 Feet

24 Feet

36 Feet

26 Feet

16 Feet

Use only

for short

run installations