www.GEAppfiances.com Safety Instructions Operating ........... 2 Instructions Air Direction ................ 4 Auxiliary Controls .......... Controls ................... Vent Control ................ Heat P_m_[J Modal _500 5-9 <' 4 Care and Cleaning Air Filters .................. Base Pan .................. Outdoor Coils .............. 0 Room Cabinet Installation and Case 11 10 10 ...... 10 Instruotions Electrical Supply' ......... Installing the Zoneline .... Preparation ...............
IMPORTANTSAFETYINFORMAtiON. READALLINSTRUCtiONSBEFOREUSING. A WARNING! For your safe_ the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. _\ "_j____SAFETY PRECAUTIONS _y_ • This Zoneline must be properly installed ira accordance with tile Installation Instructions before it is used. See the Installation Instructions ira tile back of this manual.
About the controlson yourZoneline. i ._.GE4..lia.ces.com HIGH ICOOL LOW -,,,,, FAN HEAT IAUT0 TEMP FAN TEMPCONTROL MODE FAN,MODE& OPERATION O 0 Temp Control Co;trois Tile temp I'OOIIl _A]/en 25°K control Fan, Mode & Operation Control is used Tile telilpei'attli'e.
Otherfeatures yourZoneline may have. Ventilation Control The xentilation lower control lett side cabinet, I'OOIll of the lexer is located Zoneline unit, at the behind the NOTE:Thevent door shipping hardware must be removed before using the vent control lever. See the Installation Instructions in this manual.
Auxiliary Controlson yourZoneline. _.CEA,,,ia.ces.com Auxiliary Controls- Dip Switches The au_lim y dip switch controls are located behind tile room cabinet, through an opening below the control panel. Remove tile room cabinet. Room Cabinet section. Tile ti_ctoxy settings See tile ToRemove the Dip Switches will be in tile DOWNposition. Tile owner is responsible for checking switches and ensm_ing tile) are in tile desired position.
Auxiliary controlson yourZoneline. Remote Thermostat-Class2 _4q_en this switch unit to operate _4*all Them_ostat. is enabled (UP), it allows the off of a Class 9 Remote Control The refit controls are disabled. L CLASS2 (RemoteThermostat) Load Shedding (CDC) This ti_atm'e is active only if the refit is in CDC mode. When this switch is enabled (UP), the indoor lira can be turned ON or OET with the mfit controls. LOADSHEDDING (CDC) Freeze Sentinel \,_l/en this switch is enabled (UP), it turns OFF
vvvvvv.GEApp/iances.com Temperature Limiting Temperature limiting can reduce energ 0' costs by limiting the lowest temperature that can be set fl)r cooling and the highest temI)eratm'e that can be set fin" heating. Temperature limiting is controlled by switches 1-6 on the second block aa aa a B@@ aa al of au_lim used y controls.
Auxiliary controlson yourZoneline. Auxiliary Controls-Terminal Connections The au_lia_ T controls are located behind the roon/cabinet below the control panel. _] Remove the room cabinet. See the ToRemove the Room Cabinet secdon. _ Remoxe the screws fl'om the lower panel fl'ont coxer and lift the panel off. _]_Mier all desired settings haxe been made, replace the panel and room cabinet b) rex'e_ing the above steps. The owner is responsible com_ecfions and setting dip switches.
vvww.GEAppliances.com Door Sensor (Obtained locally) _]/en when connected, tile door tile door sensor in tile i'OOill will detect W_lS opened or closed.
Careand cleaning. Room Cabinet and Case Turn the Zoneline power oiI and disconnect the supply: To clean, use water and a mild detergent. Do not use bleach or abrasives. Some commerdal cleane_ may damage the plastic parts. Outdoor Coils Tile coils on tile outdoor side of tile Zoneline should be checked regularly. If the)' are clogged with dirt or soot, they may be protessionally steaIll cleaned, a service a\_filable through your (;E se_Mce outlet.
www.GEAppliances.com To maintain optimum performance, clean the filters at least every30 days. Air Filters To remove the air filters: m_ 2 Air filters Pullup Dirty filter--Needs cleanflTg Clogged filter--Greatly reduces cooling, heating and airflow. Turnthe Zoneline offbefore cleaning. The most important thing you can do to maintain the Zoneline is to clean the filter at least every 30 days. Clogged cooling, heating and air flow.
Zoneline Air Conditioners Installation Instructions I Ouestions?Call 800.GE.CARES(800.432.2737)or Visitour BEFORE YOU BEGIN Read these instructions completely • IMPORTANT instructions fl)r local inspector's governing codes instructions • Note flmu'e with Product covered use. Be sure to leave • For personal grounded. these owner. _ Keep these instructions thilure trader responsibility due to improper the _arrantv.
Installation Instructions REPLACING AN EXISTING UNIT? Checkthe "Essential Elements"labelfor importantinformation. Use the correct wall case This unit is designed to be installed in a GE plastic or insulated metal wall case. This minimizes condensation fl'om fimning If the the cmTent possibility on the room wall case kit ]_M(901 Use correct ot the case. insulated, of condensation insulation the mfit.
Installation Instructions HOW TO CONNECT 1 I_emove the 2 Connect to electrical 3 See the supply 4 room special 230/208 xolt models ma) be installed the following electrical subbases: cabinet. Branch ¢imuit and power. below fi)r ai_plicable the r()om direct 230/208 VOLT ELECTRICAL SUPPLY A power supply Zoneline kit must refit.
Installation Instructions 265 VOLT ELECTRICAL SUPPLY /k WARNING: [] CUT AND STRIP THE CORDSET 1 Remove tile cordset fl'om Measm'e 6" down the cord fl'om the back of the nylon and cut the cord through 2 Carefidlv remove 3" of the Connection of this 965 V AC product to a branch circuit MUST be done b) direct connection in accordance with tile Natkmal Electric (;()de. Plugging this unit into a building mounted exposed receptacle is not permitted b) code.
Installation Instructions 265 VOLT ELECTRICAL SUPPLY [] REINSTALL JUNCTION BOX [] REINSTALL JUNCTION BOX COVER • Reinstall the junction box by engaging the tab at the lo_vr rea_, aligning the screw hole at the top and driving the one screw tmfil secure. Be sure that all wire leads are inside the box and not pinched between the box and the refit. The green insulated ground wire fl'om the refit MUST be connected to the branch circuit gromM wire.
Installation Instructions INSTALLING THE ZONELINE [] INSTALL THE WALL CASE AND EXTERIOR GRILLE 1 2 The l_kg71 series properly the case, instnlled Remove the protective or ILkg77 per instructions corrugated panel, as a handhold Use and _;_11 case stiffener the must Carefullx the room remoxe cabinet shiplfing tripe if'there and xent doo_; is an', t)'om with the outdoor slit in the outdoor push 1 be packed and [] PREPARE THE ROOM CABINET panel out, Shipping Pro panel tape
Installation Instructions [] iNSTALL THE UNiT iNTO THE WALL CASE Slide the unit into the wall case and secure scre_s through the unit flange [] REPLACE THE ROOM CABINET Reinstall the morn cabinet b} hooking the top oxer the rail ahmg the trait top ( l ), then I)ushing, it in at the bottom (2). with ibm" holes.
Before YouCall For Service... .CUppliances.com Troubleshooting -tips Problem Possible Causes What To Do Zoneline The * Make does notstart mlit is unplugged, The fuse breaker The is blown/dreuit is tripped, unit protector for overload the * Check the is waiting the compressor Power sure into the Zoneline the house filse or reset • This plug colnpletelv is hernial. filse/circuit the The breaker box and replace breakei: Zoneline will start again after it resets.
Thingsthat are normal Normal Operating Sounds PING! POP! "CLICK" DRIP 6 You may hear a pinging noise caused by water being picked up and thrown against tile condenser on rainy da):s or when the humidiQ' is high. This design teatm'e helps relnove moistm'e and improve efficiency. Y})u max hear relm_ click when on and off or are a(!iusted temperatm'e.
Please place in envelope and mail to: General Electric Company Warranty Registration P.O.
Consumer Deal Product Ownership Registration Customer: Thank you for purchasing VVe are proud Follow our product and thank you for placing your confidence in us. to haxe you as a customer! these three steps to protect your new appliance investment: Complete and mail your Consumer Product Owuership Allcr mailing the registration below, [_(_a(t store It will help you Registration today. t ]avc the t)eacc ot mind of knowing we can contact you in in a sad place.
Zoneline Warranty. Staple your receipt here. Proof of the original purchase date is needed to obtain service under the warrantg or an authorized Customer Care® technician. Toschedule service, II warranty service provided by our Factory Service Centers, on-line, 24 hours a day, vis# us at www.GEAppfiances.com, or call 800.GE.CARES(800.432.2737).For service in Canada, call 1.800.361.3400. _ For The Period Of.
ConsumerSupport. Ha_e a question ' or need assist;race with your appliance? Tr_ the GE Appliances _4'ebsite 24 hom_ a day, and tipster service, you can now download Owner s Manuals, or e_en schedule service on-line. You can also "_sk Our Team of Expe_ls .... l an_ GEAppliances day of the _ear! For greater Website con;enience order } O/lI" parts, catalogs, qtlestions, and so Ill t/ch Ill ore... ScheduleService Expert GE repair your, comenience business hom_. vvvvvv.GEAppliances vvvvvv.