Data Manual

35
RAK204 SERIES SUB-BASE INSTALLATION AND ELECTRICAL DATA
RAB71B/77B Wall Sleeve
RAK4002D
CHASEWAY OPTION (Shown Without Chassis and Wall Sleeve for Installation Location Only.)
NOTE: TYPE “E” MOUNTING CLIP MUST BE USED WITH MOLDED Sleeve.
MOLDED
Sleeve
SUB-BASE
MOUNTING CLIP
TYPE “E”
TYPE
“D”
USE WITH
RAB71B
TYPE
“E”
USE WITH
RAB77B
TYPE “A” TYPE “B” TYPE “C”
6 REQ’D. 2 REQ’D. 8 REQ’D.
GREEN
GROUND
SCREW
(TYPE “C”)
METAL Sleeve
SCREW CLIP
TYPE “D”
TYPE “A”
SCREW
TO SECURE
SIDE CHANNELS
6"
5/32" DIA. HOLE (SEE NOTE) FOR SECURING TYPE “D” CLIPS TO SLEEVE USING TYPE “A” SCREWS
6"
TYPE “A”
SCREW
TYPE “C”
SCREW
ACCESS PLATES
TYPE “C”
SCREW
TYPE “B” SCREW
SIDE CHANNELS ARE ADJUSTABLE FROM 13-3/4" TO 2-3/8" IN LENGTH BY BREAKING OFF SECTIONS OF SIDE CHANNELS.
NOTE: IF METAL Sleeve DOES NOT HAVE SCREW HOLES, 5/32" DIA. HOLES MUST BE DRILLED 6" FROM EACH SIDE IN FRONT FLANGE. (SEE INSERT).
Electrical wiring may enter the sub-base through any of the knockout holes provided in the sub-base. Knockout holes in the sub-base access plate may accommodate a receptacle, which allows the use of a power cord (if permitted by code for the particular installation). A knockout for a circuit breaker, fuseholder or a disconnect is also provided. See page 25 for description of electrical contents of these sub-bases.
WALL SLEEVE INSTALLATION DATA (CONTINUED)