Installation Guide

Lighting Solutions

Installation Guide

imagination at work

Modular High & Low Bay Lighting

ABHG-Series CE

Albeo

LED Luminaire

WARNING

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation

or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all local codes.

• Use only IEC approved wire for input/output

connections. Minimum size 18 AWG (0,75mm

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

Electrical Requirements

• The LED luminaire must be connected to the mains

supply according to its ratings on the product label.

• Use an input cord with 3 conductors each with a

cross-section between 1,5mm

and 2,5mm

of type

HD-21 or HD-22.

• Suitable for use indoors.

Grounding Instructions

• The grounding and bonding of the overall system

shall be done in accordance to local electric code of

the country where the luminaire is installed.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

PAGE 1
Installation Guide GE Lighting Solutions Albeo LED Luminaire TM Modular High & Low Bay Lighting ABHG-Series CE BEFORE YOU BEGIN Read these instructions completely and carefully. Save These Instructions Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. Prepare Electrical Wiring Electrical Requirements • The LED luminaire must be connected to the mains supply according to its ratings on the product label.
PAGE 2
Luminaire Installation 1 Carefully unpack unit and properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to the luminaire. 2 Select the appropriate mounting method based on the ordering number logic chosen. Attach to structural member Fixture Weight ABHG-series LED Modules 1 module 2 modules 3 modules 4 modules 3 Rod mount bracket 6 Mounting inserts Max.
PAGE 3
DALI 3 Connect the AC line to the power terminal block as follows: Brown to L1, Blue to N, and Green/yellow to ground. Reattach endcap if there is no dimming line. 4 1-10V Optional DALI and 1-10V Dimming: Follow wiring diagram below. Reattach endcap.