User Manual

B1X5 Wi-Fi Module Operation Manual

B1X5 Wi-Fi Module provide WLAN baseband processor and RF transceiver and

support IEEE Std 802.11a, 802.11b, 802.11g and 802.11n HT20 and HT40 SISO and

802.11n HT20 2*2 MIMO at 2.4 GHz for High Throughput.

B1X5 Wi-Fi Module Peripheral circuit is developed by GE Healthcare and the

Wireless chips is used WL1837 from TEXAS INSTRUMENTS. WL1837 has been

certified for FCC with FCC ID: Z64-WL18DBMOD. GE Healthcare apply independent

FCC ID for B1X5 Wi-Fi Module and has passed the FCC Certified test with FCC ID:

OU5B1X501.

B1X5 Wi-Fi Module just will be used in GE Healthcare Value Monitor (B1X5 series)

patient monitors. B1X5 Wi-Fi Module will be configuration and operation through

GE VSP main software. B1X5 Wi-Fi Module will not be sale and used separately.

Pin definition:

The pin definition of B1X5 Wi-Fi Module as below picture:

PAGE 1
B1X5 Wi-Fi Module Operation Manual B1X5 Wi-Fi Module provide WLAN baseband processor and RF transceiver and support IEEE Std 802.11a, 802.11b, 802.11g and 802.11n HT20 and HT40 SISO and 802.11n HT20 2*2 MIMO at 2.4 GHz for High Throughput. B1X5 Wi-Fi Module Peripheral circuit is developed by GE Healthcare and the Wireless chips is used WL1837 from TEXAS INSTRUMENTS. WL1837 has been certified for FCC with FCC ID: Z64-WL18DBMOD.
PAGE 2
Assembly Process: The B1X5 Wi-Fi Module just can be used in Value Monitor (B1X5 series) patient monitors, the assembly process as below: Steps: 1. Assemble the WLAN module corresponding pins to the corresponding connector in the WLAN module slot. 2. Install two screws on the wireless board. 3. Connect two antennas to WLAN module and use the clips to fix the antennas.
PAGE 3
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.