Installation Instructions

175 Science Parkway, Rochester, New York 14620 USA
[phone] Phone
[phone] Fax
May 22 2003
FEDERAL COMMUNICATIONS COMMISSION
7435 Oakland Mills Road
Columbia, MD 21046
U.S.A.
Subject: FCC part 15 unlicensed transmitter Professional installation request.
Applicant: Microwave Data Systems Inc.
Product: ENET Serial Remote
Model: ENET900SR
FCC ID: E5MDS-ENET900SR
Dear Sir/Madam,
The MDS ENET family of products is a Professional Installation Radio System and must be Installed by Trained
Professional Installers, or Factory Trained Technicians.
MDS has distributors, channel partners, and a field service department, that have all been trained in “Professional
Installation” of part 15 unlicensed products. These products are NOT for sale to the general public and used for industrial
applications where professional installers are used the system planning for path loss, cable selection, and antenna gain
calculations.
Our manual and all sales brochures will clearly list this system as “professional installation” is required.
Below is an excerpt from our manual
This section is designed to aid the professional installer in the proper methods of maintaining compliance with the FCC
part 15 limits and the +36 dBm or 4 Watts peak E.I.R.P. limit
If you have any queries, please do not hesitate to contact me at 585 242-8440:
Yours truly,
Dennis McCarthy
Agency Compliance Engineer
Microwave Data Systems
175 Science Parkway
Rochester NY 14620
Phone [phone]
Email [e-mail]