Log ID: 100001_1
Log ID: 100002_4
Log ID: 100003_3
Update grammar to the following Select the WiFi Network you want to connect to Log ID: 100013_1
iOS & Anroid Update grammar to the following Your reach device has successfully connected. You need to add the device to an existing place or create a new place to continue. Note: When adding to an existing place, please ensure ALL other devices associated with this place are powered ON and within range. Failure to do so will result in loss of previously saved settings. (i.e. lost schedule, bulb color, etc.
reach device support Log ID: 100026_2
reach Device Support 1) Navigate to the Home tab and click on 2) Click “Add New Bulb(s)” OR 1) 2) 3) 4) Make sure the reach device is paired to the correct network Press and release the button on the side of the reach device Once you see the LAN LED flashing, the hub has started adding devices Please wait a few moments while devices are added Log ID: 100029_1
Log ID: 100030_3
reach Device Support LED Power LAN WAN Operation power on/initialization config/reset connecting to router connection fail connection success scanning devices connection fail connection success Action slow flash fast flash slow flash fast flash steady on quick flash steady off steady on Action Description slow flash 0.5 Hz quick flash 1.5 Hz fast flash 5.
reach Device Support 1. Unplug the reach device from the wall outlet 2. While holding the button on the reach device, plug it back into the wall and continue holding the button for at least 3 seconds 3.