User's Manual

1. Factory new: bulb with certain mesh name and password, concrete content

depend on customer.

2. Log in at first time: user use the default mesh name and password to

3 times after modifying successfully. The device which use same mesh

name and password should under same network.

3. Reset device: if user forget the mesh name and password they set, they

could rest the device through on/off 5 times the device. Concrete

operations as follow: power on and off the device 5 times, former 3

times interval time less than 3s, last 2 times on/off operation

interval time between from 3 to 30s. After above operation light will

flash 3 times which means match successfully.

4. OTA upgrade: user could use APP to upgrade the light, light will flash

3 times slowly which means upgrade successfully, if light flash 3 times

quickly, it means upgrade failed.

5. Control function: the light has function of on/off, lumen control and

group control.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may

cause undesired operation.

NOTE: Any changes or modifications to this unit not expressly approved

by the party responsible for compliance could void the user's authority

to operate the equipment.