User Manual

14210 ver1 8/14
FCC statement
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
FCC NOTE: The manufacturer is not responsible
for any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures: reorient or relocate the receiving
antenna, increase the separation between the
equipment and receiver, or connect the
equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
CAUTION
BATTERIES MAY LEAK HARMFUL LIQUIDS OR
IGNITABLE MATERIALS OR EXPLODE CAUSING
INJURY OR PRODUCT DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER
BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME TIME
• REPLACE FULLY DISCHARGED BATTERIES
IMMEDIATELY
• REMOVE BATTERIES IF PRODUCT IS TO
BE UNUSED FOR EXTENDED PERIOD OF TIME
LED Lantern
User’s Guide
The lantern can be operated with 3 or 6 D-cell batteries. Batteries must be installed or
replaced in sets of three. NOTE: If replacing the batteries, remove the old batteries and
follow the instructions below.
battery installation:
illustration 1
illustration 2
illustration 3
using the latching handle:
1. To open the handle, depress the raised
button near the bottom of the handle.
See illustration 1.
2. Fully open the handle.
3. Close handle around object you wish the
lantern to hang from. See illustration 2.
4. Open the raised button. Be sure the
handle is securely latched before allowing
lantern to fully hang on its own.
See illustration 3.
• Do not attempt to hang lantern with
handle in open position.
• Always be sure to hang the lantern in a
safe and secure area.
• Lantern should never be left out in
excessive wind.
1. Turn the lantern over and remove
the battery cover by twisting the cap
counter clockwise. The battery sets are
marked by white and green stickers.
2. If you want to run the lantern from
3 D cells, fill either the white or the
green positions noting proper battery
polarity.
3. If you want to run the lantern from
6 D cells, fill both the white and green
positions noting proper battery polarity.
4. Replace the battery cover and
twist clockwise to close.
Made in China
GE is a trademark of General Electric Company
and is under license by Jasco Products Company
LLC, 10 E. Memorial Rd., Oklahoma City,
OK 73114.
This Jasco product comes with
a 3-year limited warranty.
Visit www.jascoproducts.com for details.
Questions? Contact us at 1-800-654-8483
between 7:30AM—5:00PM CST.