WA WMDG-228 DISHCreek Module User Manual Version 0.1 Gemtek Technology Co., Ltd. www.gemteks.com No.15-1 Zhonghua RoadIndustrial Park, HuKou Hsiang, HsinChu Hsien,Taiwan, R.O.C.
Revision History Revision Date 0.
Copyright © 2005-2006 GEMTEK TECHNOLOGY CO., LTD. This document is copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of GEMTEK TECHNOLOGY CO., LTD. Notice GEMTEK TECHNOLOGY CO., LTD. reserves the right to change specifications without prior notice.
WMDG-228 Module Feature Overview ➢ Form Factor LGA2522: 25mm x 21.8mm ➢ RF BAND: FDD Half duplex(LB+HB) ➢ SYSTEM LTE Chipset: GDM7243i Flash: Quad Flash(MX25U12835FXDI-10G) USIM (1.8V and 3.0V) USB/I2C/I2S/UART0123/ADC SDIO/PWM/JTAG/GPIOs BLE: Supported (SW disables BLE) Manufacturing Process This section describes board-level characterization process parameters. During board’s reflow process, the temperature seen by the package must be controlled.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Professional installation instruction Please be advised that due to the unique function supplied by this product, the device is intended for use with our interactive entertainment software and licensed third-party only. The product will be distributed through controlled distribution channel and installed by trained professional and will not be sold directly to the general public through retail store. 1.
Integration instructions for host product manufacturers Applicable FCC rules to module FCC Part 27 Summarize the specific operational use conditions The module is professional installed equipment and must be installed in mobile device.
Antennas Dipole antenna with 1.23 dBi gain, SMA connector Label and Compliance Information Product manufacturers need to provide a physical or e-label stating “Contains FCC ID: MXFGCM7243IDS-APB” with finished product. Information on Test Modes and Additional Testing Requirements Simulator is required to link up and set the module to transmit at specific frequency, output power level under operation mode.