Installation Instructions

Instructions of Remote Control

1. Please pull out the insulation tape from the remote control,before starting to use it.

2. Press the button to select functions.The functions are :

ON : turn on the lights

OFF : turn off the lights

TIMER : start or cancel timing ( 6 hours “on”,18 hours “off”)

STEADY WARMWHITE : steady warm white

STEADY MULTI : steady multicolor

SLO-GOL : fading warm white & multicolor

TWINKLE/FLASH : twinkle / flash warm white & multicolor

DIM - : decrease the brightness

DIM + : increase the brightness

Instructions of 2 button control

1. Press RUSH button , select lighting functions below cycle.

Function 1: steady warm white.

Function 2: steady multicolor.

Function 3: fading warm white & multicolor.

Function 4: twinkle / flash warm white & multicolor.

2. Press ON/OFF button , turn on or turn off the lights.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

FCC ID: 2AV4T-QY-M2