Digital Throttle (E7033) User Manual
INSTRUCTION TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a typical installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Digital Throttle: The Gatekeeper Systems E7033 Digital Throttle transceiver is designed to be mounted in the Gatekeeper Systems, Inc. Cart Manager. The Digital Throttle will operate with Gatekeeper Systems CM Remote, Gatekeeper Systems wheels and responds to Gatekeeper Systems status requests. Digital Throttle connectors detail: Connector Block 1 Connector Block 2 Power up Digital Throttle, by providing +12V DC power supply at connector block 1 pin 3 and grounding at connector block 1 pin 4.
Connector Block 2 Definitions: Pin Name Description 1 GND IN Power Grounding 2 ASSO SW CM Remote Associate Switch 3 V_TO_C Output Voltage to the controller 4 F_V_IN Input FWD voltage 5 F_TO_C FWD voltage output 6 SW1 IN Input Key switch 7 T_V_IN Throttle Voltage Input 8 E_LED_P Error LED input 1 9 POT HI Potentiometer High voltage input 10 E_LED_C Error LED Input 2
Contacting Gatekeeper Systems For more information about the Door Manager and troubleshooting, to order parts or report an issue, contact the Gatekeeper Systems Inc. regional Customer Support office nearest to your location. Hong Kong Gatekeeper Systems (HK), Ltd. Unit 2318~2319, Level 23, Tower 1, Metroplaza NO. 223 Hing Fong Road, Kwai Fong, N.T., HONG KONG (852) 2413 3050 USA Gatekeeper Systems, Inc. 8 Studebaker Irvine, CA 92618 (888) 808-9433 Canada Gatekeeper Systems Canada, Ltd.