Carttronics CRFII User Manual
INSTRUCTION TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a typical installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
1. CRFII CRFII is part of the Carttronics’ Push-Out Prevention System (POPS™) on a shopping cart. It involves Web Integrator, TX2, Permit Issuer, Sentry and the wheel Casters. It collects diagnostics from the Cattronics network to the Carttronics data center. It allows Carttronics service personnel to remotely monitor, configure and manage a Carttronics installation. We use this information to generate loss prevention, asset management, operations improvement, and resource allocation reports for customers.
1.3 CRFII – Permit Issuer /Sentry 1.3.1 Permit Issuer The Permit Issuer (PI) is a network device used in Carttronics Push-Out Prevention System (POPS™) that authorizes casters and beacons to exit the store within a programmable time limit. Fig.3 Permit Issuer Diagram 1.3.2 Sentry Sentry is used to drive two small 8Khz loops Fig.
3. INSATALLATION 1. Mount the CRFII on the table or on the wall by screws. Screw Screw Contacting Gatekeeper Systems For more information about the Module and troubleshooting, to order parts or report an issue, contact the Gatekeeper Systems Inc. regional Customer Support office nearest to your location. Hong Kong Gatekeeper Systems (HK), Ltd. 36/F, Tower 2, Times Square 1 Matheson Street, Causeway Bay, Hong Kong HONG KONG (852) 2822 0132 USA Gatekeeper Systems, Inc.