Installation Guide

CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
PREPARATION
Tools Required for Assembly: (Not included)
•Pencil
•Electrical drill with 9/32in. drill bit
•Hammer
•Philips head screwdriver
•Tape measure
• Level
•Safety Glasses
• Hack saw
CAUTION : Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
Fig. 3
3.
Fasten mounting
bracket to wall with
mounting screws.
(Fig. 3)
4.
Using hack saw, cut
shower rod to desired
length (if necessary).
(Fig. 4)
Fig. 4
CURTAIN ROD
CUT ROD LENGTH 1/4” SHORT OF
MEASURED SPACE
Fig. 6Fig. 2
1.
Fig. 1

WALL



A
B
Use back plate as an
outline to mark desired
position on wall and
location of mounting
screw holes.
Fig. 5
 
5.
Assemble shower rod
by pushing end base
into rod.
(Fig. 5)

6.
Slide assembled
shower rod over
bracket and tighten
set screw.
(Fig. 6)
2.
Drill 9/32 in. pilot holes
into the wall where
the molly bolts will
be inserted using an
electrical drill. Tap molly
bolts into the pilot holes
using a hammer. Use an
electrical screwdriver to
tighten the screws. This
will collapse the molly
bolts tightly to the wall.
Unscrew the screws
from
the molly bolts. Molly
bolts will remain in the
wall. (Fig. 3)
General Installation Instruction
Shower Curtain Rod
The manufacturer reserves the right to, and do time to time, make changes and improvements in designs and dimensions.
Updated on December 20, 2021