Operating Instructions Latté Art Milk Frother Advanced Art.-No.
Carefully read all provided instructions before you start running the appliance and pay regard to the warnings mentioned in these instructions. Table of Contents Dear Customer!.................................................................................................25 Knowing Your Latté Art Milk Frother Advanced.....................................................25 Important safegards...........................................................................................
Dear Customer! Congratulations! An astonishing forward-looking technology comes with your new Gastroback Latté Art Milk Frother Advanced. Without any effort you prepare delicious silky milk froth for coffee, cacao, milk drinks and even refined desserts. You can freely select the desired temperature, thus always getting best results. According to the innovative induction heating technology, the Milk Frother works without any heating plate—only the jug is heated.
Cappuccino frothing disc – for thick and creamy froth. Latté frothing disc – for smooth and silky milk. On-board disc storage – a magnet firmly secures the frothing disc. Coupling of the stirrer – a rotating magnet agitates the frothing disc contact-less.
Important safeguards Carefully read all instructions before operating this appliance and save for further reference. Do not attempt to use this appliance for any other than the intended use, described in these instructions. Any other use, especially misuse, can cause severe injuries or damage by electric shock, moving parts, heat, or fire. These instructions are an essential part of the appliance. Do not pass the appliance without this booklet to third parties.
and where young children cannot reach it. Do not leave the appliance or any part of it unattended, when it is in reach of young children. • Do not place the appliance or any part of it on or near hot surfaces (e.g. burner, heater or oven). Do not use any parts of the appliance with any other device or for any other purpose. Do not handle the appliance or any part of it with violence. • Do not use any hard, sharp or edged objects (e.g. knives, forks) with the appliance.
Important Safeguards for Electrical Appliances The appliance is driven electrically. Place the appliance near a suitable wall power socket to connect the appliance directly to a protected mains power supply with protective conductor (earth/ground) connected properly. Ensure that the voltage rating of your mains power supply corresponds to the voltage requirements of the appliance (230 V, 50 Hz, AC, rated for at least 10 A). The installation of a residual current operated circuit breaker (r.c.c.b.
Moving Parts The stirrer of the appliance is driven electrically via a magnet. Thus, you should always avoid inserting your hands, or any delicate objects in the jug, when the jug is placed on the power base and the appliance is connected to the power supply. Technical Specifications Modell: Art.-Nr. 42360 Latté Art Milk Frother Advanced Power supply: 230-240 V AC, 50/60 Hz Power consumption: 500 W Length of power cord: ca. 1.05 m Weight: ca. 1.65 kg Dimensions: ca. 14.0 cm x 15.4 cm x 26.
Safety Concept For your protection and convenience, your new Milk Frother offers an innovative design. • After 30 seconds of being idle the Milk Frother will switch off automatically and the indicator goes out. To start operation again, simply press the START/STOP button. • Overheat Protection: The Milk Frother will automatically cease to operate, if the jug overheats. Possible reasons: – The jug is empty, or liquid is below the MIN filling mark. – Consecutive uses without sufficiently pausing.
- Further ingredients: acidity and fat content of the ingredients have a great effect on frothing. Adding powdery ingredients could in some cases prevent the build-up of froth (e.g. cacao powder). As an example, you can add the following ingredients: cacao powder, mixtures for chocolate drinks and chai tea, flakes of chocolate, syrups (e.g. of maple, berries, woodruff), honey. • Even the time of adding ingredients can be of great effect on the results. Some ingredients (e.g.
Operation WARNING: Always ensure that the appliance and all its parts and accessories are out of reach of young children. This holds especially for the frothing discs that could be swallowed by young children, thus causing risk of suffocation. The appliance is intended for heating and mixing milk and milk surrogates (e.g. cow milk, soy milk). Therefore, the jug can get very hot during operation.
Preparing the Appliance WARNING: Only place the appliance on a stable, dry, level, and clean surface. Do not place the appliance on inclined surfaces. Do not place any clothes or tissue or other foreign objects on or under the appliance during operation, to avoid risk of fire or electric shock. Do not block the ventilation slots at the bottom and rear of the power base. During operation, the operating elements (see: Knowing Your Latté Art Milk Frother Advanced) must be accessible any time.
Frothing Milk 1. Connect the appliance to the power supply. The indicator in the START/STOP push dial illuminates. Tip: After being idle for 30 seconds the Milk Frother will enter standby mode (indicator goes out, fan stops working). Simply press the START/STOP button once to re-activate the appliance. 2. Turn the selection dial to the desired temperature. See: Tips for Best Results If temperature setting is changed during operation, the appliance will stop at the new temperature.
Adding Further Ingredients WARNING: Ensure not to spill any liquids on the appliance, when adding further ingredients through the opening in the lid. Do not overfill the jug. Do not remove the lid, while the appliance is operating. Always pour further ingredients through the opening for the measuring cup. Otherwise the jug could overflow, and liquid could drip on the power base, causing electrical hazard. Additionally, the contents of the jug could splash, when pouring in further ingredients.
Solving Problems If any problems occur during operation, you will find solutions in this section. Problem Reason The Solution Milk is not frothing Appliance is not heating. Frothing disc is not moving or is dislodged. •Start with cold, fresh milk. Do not re-foam already heated milk. Try reducing milk volume in jug. The jug is not placed properly on the power base. • Ensure jug is correctly positioned onto power base. The process has not yet been started.
The appliance suddenly stops. Power failure. • Ensure that the power outlet is live. The overheat protection is active. • Unplug the appliance and wait for the appliance to cool down (approx. 5 minutes). Thereafter you can continue working as usual. The thermal cut-out is active. • Unplug the appliance and send the appliance to an authorized service centre for repair.
Note: The seal on the lid can be removed and washed separately. However, do not use any hard or sharp-edged objects for removing and cleaning the seal to avoid damage to lid and seal. 5. Wipe the power base with a soft, damp cloth. WARNING: Always ensure that the appliance and all parts of it are out of reach of young children. 6. Dry all parts of the appliance thoroughly and let all parts dry naturally were they are out of reach of young children. 7.
Notes for Disposal Dispose of the appliance and packaging must be effected in accordance with the corresponding local regulations and requirements for electrical appliances and packaging. Please contact your local disposal company. Information and Service Please check www.gastroback.de for further information. For technical support, please contact Gastroback Customer Care Center by phone: +49 (0)4165/22 25-0 or e-mail info@ gastroback.de.
Recipes Hot Chocolate Select cappuccino frothing disc Ingredients (2 portions): 250 ml cold fresh milk; 1 - 2 teaspoon shaved chocolate, melted chocolate or cacao powder; caster sugar to taste Add milk in the jug and allow to heat and froth at the desired temperature setting (recommended: 60 °C) for 30 seconds. Then add chocolate/cacao and sugar slowly and in small portions. Cappuccino A composition of 1/3 lukewarm espresso, 1/3 hot milk, and 1/3 of milk froth. Select cappuccino frothing disc.
Chai Latté Select latté frothing disc Ingredients (1 portion): 250 ml fresh, cold milk, 1 portion chai latté tea concentrate, some grounded nutmeg or cinnamon. Fill milk in the jug and select the desired temperature. After approx. 30 seconds slowly add the tea concentrate. After processing of milk has been finished, pour out and top with nutmeg or cinnamon to taste. Flat White Select latté frothing disc Ingredients (1 portion): 1 small cup espresso, 250 ml fresh, cold milk.
Index A abroad operation............................. 29 accessories....................................... 27 P parts .............................................. 25 power consumption .......................... 30 power cord .........................29, 30, 32 power supply ............................ 29, 30 preparation ..................................... 34 properties........................................ 30 C capacity ................................... 30, 34 care and cleaning...................
GASTROBACK GmbH Gewerbestraße 20 . D-21279 Hollenstedt / Germany Telefon +49 (0)41 65/22 25-0 . Telefax +49 (0)41 65/22 25-29 info@gastroback.de . www.gastroback.
