SOLARIS RADIANT CERAMIC HEATERS OPERATION, INSTALLATION AND MAINTENANCE MANUAL DANGER SOLARIS DELUXE If you smell gas: 1. Shut off the gas to the appliance. 2. Extinguish any open flame. 3. If odour continues, keep away from he appliance and immediately call your gas supplier or your fire department. Do not store or use gasoline or other flammable vapour and liquids in the vicinity of this or any other appliance.
Table of Contents Important Safety Rules 1 Product Overview 2-3 Installation Servicing 4-6 Operation Instructions 7-11 RH200 Auto Electrical Diagram 12 RH200 Automatic Ignition Overview 13-14 Safe Appliance Locations 15 Troubleshooting 16 Spare Parts 17-18 Installation, Operation and Maintenance Instructions IMPORTANT SAFETY RULES 1. This appliance shall not be installed or used indoors, in buildings, garages or any other enclosed area. 11.
PRODUCT OVERVIEW Prior to Installation and Assembly of your appliance, the following must be reviewed. Compliance with the following should result in satisfactory heater operation. This instruction manual should be retained for future reference. The installation must conform with local codes or authority having jurisdiction. 1. The appliance is intended for heating residential and non-residential outdoor spaces. The installation must conform with local codes and with the Australian Standard AS/NZS 5601.
PRODUCT OVERVIEW LPG GUIDELINES 1. The hose must be protected from contact with hot or sharp surfaces both during use and while in storage. The hose assembly should be visually inspected prior to each use of the appliance. If excessive abrasion or wear is evident, or the hose is cut, it must be replaced prior to operating the appliance. The replacement hose assembly may be obtained from the manufacturer. 2. 3.
INSTALLATION AND SERVICING ESSENTIAL INFORMATION HEATER ASSEMBLY The warranty to the product will be voided if any component of the patio heater is tampered with, or altered. NOTE: Recommended clearances must be maintained. To have these units altered or serviced by an unauthorised person may render the product inefficient, and at worst dangerous. * Remove transit protection material.
INSTALLATION AND SERVICING RADIANT CERAMIC HEATER IMPORTANT Minimum Clearances from Combustible Surfaces*: This appliance must only be used in a well ventilated area. *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
INSTALLATION AND SERVICING LEAK TESTING THE PRODUCT IMAGE 1 A gas leak test must be done after assembly and before operating the appliance. Procedure as follows: 1. If the product is installed on Natural Gas, the hose & regulator must be connected to both the heater and mains supply. If the product is installed on LPG then the hose & regulator must be connected to both the heater and a full gas cylinder.
RH200 SOLARIS DELUXE HEATER – OPERATING INSTRUCTIONS START - TURNING THE HEATER ON 1. IMAGE 1 Before operating this appliance: IMPORTANT It is imperative that you ensure that the gas installation and power installation has been carried out in accordance with the manufacturers guidelines in this instruction manual. A certificate of compliance should be provided by the licenced installer at the completion of any installation. Make sure you read the instruction manual thoroughly prior to use.
RH200 SOLARIS DELUXE HEATER – OPERATING INSTRUCTIONS 6. Ignition Failure: If the heater fails to ignite, then turn the power off at the power point. IMPORTANT - Wait 10 seconds, then turn the power back on at the power point. If the heater fails to ignite after 6 attempts, refer to the troubleshooting guide in the back of the instruction manual for further guidance or alternatively contact the Sitro Service Team on 1300 174 876 (Mon – Fri) 8.00am – 5.00pm or Email service.group@sitro.
RH205 SOLARIS HEATER – OPERATING INSTRUCTIONS START - TURNING THE HEATER ON 1. IMAGE 1 Before starting this appliance: IMPORTANT It is imperative that you ensure that the gas installation and power installation has been carried out in accordance with the manufacturers guidelines in this instruction manual. A certificate of compliance should be provided by the licenced installer at the completion of any installation. Make sure you read the instruction manual thoroughly prior to use.
RH205 SOLARIS HEATER – OPERATING INSTRUCTIONS 6. IMAGE 4 Ignition Failure: If the heater fails to ignite after 6 attempts, refer to the troubleshooting guide in the back of the instruction manual for further guidance or alternatively contact the Sitro Service Team on 1300 174 876 (Mon – Fri) 8.00am – 5.00pm or Email service.group@sitro.com.au for technical support. STOP - TURNING THE HEATER OFF 1.
RH200 SOLARIS DELUXE AUTO ELECTRICAL DIAGRAM WIRING DIAGRAM - HONEYWELL CONTROL, HONEYWELL GAS VALVE ELECTRICAL DIAGRAM NOTE: THIS DIAGRAM IS SPECIFICALLY FOR THE RH200 AND IS NOT APPLICABLE FOR THE RH205 12
OPERATION DATA HONEYWELL CONTROL BOX Directions for use • The following operation sequence is valid only where the components are installed according to the manufactures assembly and installation instructions. Please do not modify the wiring configuration, gas train or any other part of the heater assembly. Automatic controls are safety devices and shall not be opened. The manufacturer’s responsibility and guarantee are invalid if the control is unduly opened.
RH200 SOLARIS DELUXE AUTO ELECTRICAL DIAGRAM OPERATION DATA - HONEYWELL VALVE The VK series gas control have been specially developed for application in domestic appliances. The Honeywell Gas Valve is a multi-functional control which incorporates an adjustable direct acting pressure regulator. It is designed for operation on 220~240V AC 50Hz. Standard Specifications • 3/8” SAE Male Thread connection. • Ambient Temperature Range of 0°C to 60°C. • Compact Size: 86.5mm x 63.5mm x 65.9mm.
SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).
TROUBLESHOOTING, CLEANING AND MAINTENANCE TROUBLE SHOOTING Fault Main burner (Tiles) will not light Main burner (Tiles) will not light fully Main burner (Tiles) cut out Low heat output Causes Remedy Action (a). Air in gas line Purge gas line Contact Licenced Gas Installer (b). Blockage in gas line Trace back and clear Contact Licenced Gas Installer (c). Igniter not sparking Repair lead, electrode, piezo or replace Contact Licenced Gas Installer (d).
IMPORTANT The following parts must be installed by a licenced installer.
IMPORTANT The following parts must be installed by a licenced installer.
NOTES 19
For any queries or assistance call Customer Service (Australia Only) 1300 174 876 Hours of operation: Monday to Friday 8am - 5pm EST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty.