Replacement Part List

30-Gallon

Gas Caddy

Model No. GG-30GC

Owners Manual

For Service Assistance

Phone Toll Free 1-800-433-0708

1. Attach the green ground wire clamp to a known ground on the vehicle being serviced.

. Place the suction/drain hose in the vehicle.

3. Rotate the pump handle briskly to obtain initial prime.

4. Rotate the handle clockwise (as shown by the arrow on the pump) to draw from the gas caddy , rotate counter-

clockwise for suction.

5. The gas caddy may also be filled by removing the fill cap and filling through the fill tube. DO NOT OVERFILL. Fuel

level must be below the flame arrestor screen under the fill tube.

Operation

Rev 10/15

PAGE 1
Operation 1. Attach the green ground wire clamp to a known ground on the vehicle being serviced. ® 2. Place the suction/drain hose in the vehicle. 3. Rotate the pump handle briskly to obtain initial prime. 4. Rotate the handle clockwise (as shown by the arrow on the pump) to draw from the gas caddy , rotate counterclockwise for suction. 5. The gas caddy may also be filled by removing the fill cap and filling through the fill tube. DO NOT OVERFILL.
PAGE 2
Please Read The Following Warnings Before Assembly and Use of the Gas Caddy Gasoline Danger Extremely Flammable Vapors Can Explode Harmful Or Fatal If Swallowed Assembly Tools Required 4mm Hex Wrench 5mm Hex Wrench Adjustable Wrench Phillips Screwdriver PTFE Tape (Included) Fig 2a Fig 1 Assembly Procedures 1. Remove the gas caddy tank, pump, handle, and accessory kit from the carton. 2. Remove nylon insert nut, washers, and shoulder bolts from tank. Assemble handle and reinstall hardware to tank.