User's Manual

ManualsBrandsGarrett Metal Detectors ManualsElectronicsWireless/LBC

2350699 Rev. A

Wireless/Light Bar Controller

Integration Instructions – User Manual

(Ref. KDB 996369 D03 OEM Manual v01)

FCC ID: DBDWLBC6100; IC: 20318-WLBC6100, HVIN 2350600

§2.2 List of applicable FCC rules:

The Wireless/Light Bar Controller Module (Wireless/LBC, WLBC) complies with the

following FCC CFR47 Part 15 Subpart C regulations:

§15.203 Antenna Requirement

§15.204 External radio frequency power amplifiers and antenna

modifications.

§15.212 Modular Transmitters

§15.207 Conducted Limits

§15.247 Operation within the bands 902-928 MHz, 2400-2483.5 MHz, and

5725-5850 MHz (digitally modulated)

FCC CFR47 Part 15 Subpart A—General

§15.19 Labeling requirements

§15.21 Information to user

§2.3 Operational Use Conditions:

The WLBC module has been approved for use in the US, Canada, Australia/New

Zealand, and Europe.

Changes or modifications to the module could void the user’s authority to operate the

module.

The host product operating conditions must be such that there is a minimum separation

distance of 20 cm between the antenna and nearby persons.

§2.4 Limited Module procedures:

The WLBC has full modular approval.

§2.5 Trace antenna designs:

The WLBC does not require Micro-Strip antennas or traces on the host device. All

traces and antennas are contained on the WLBC PCB.

Summary of content (3 pages)

PAGE 1
Wireless/Light Bar Controller Integration Instructions – User Manual (Ref. KDB 996369 D03 OEM Manual v01) FCC ID: DBDWLBC6100; IC: 20318-WLBC6100, HVIN 2350600 §2.2 List of applicable FCC rules: The Wireless/Light Bar Controller Module (Wireless/LBC, WLBC) complies with the following FCC CFR47 Part 15 Subpart C regulations: §15.203 Antenna Requirement §15.204 External radio frequency power amplifiers and antenna modifications. §15.212 Modular Transmitters §15.207 Conducted Limits §15.
PAGE 2
§2.6 RF exposure considerations: The host product operating conditions must be such that there is a minimum separation distance of 20 cm between the antenna radiating structures and nearby persons. The host manufacturer is obligated to confirm the use conditions of the host product to ensure that the distance specified in the instructions is met. In this case the host product is classified as either a mobile device or a fixed device for RF exposure purposes. Maximum EIRP of the module is 8.
PAGE 3
§2.9 Information on test modes and additional testing requirements: Host manufacturer should confirm proper operation using a known good module to link to the installed module. Test procedure for the host will require a particular setting to address the good module and proper operational response will be checked. §2.10 Additional testing, Part 15 Subpart B disclaimer: The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules, i.e., §15.207, §15.