Varia™ Bike Lights Owner’s Manual August 2015 Printed in Taiwan 190-01906-00_0A
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product.
Table of Contents Introduction.....................................................................1 Getting Started ............................................................................ 1 Charging the Device ................................................................... 1 Installing the Out-Front Mount .................................................... 1 Installing the Seat-Post Mount .................................................... 1 Installing the Multi-Location Mount ..................
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Always consult your physician before you begin or modify any exercise program. Getting Started You can use the Varia HL (headlight) and Varia TL (taillight) alone, with the optional wireless remote, or with your compatible Edge device. This list provides an overview of the installation and setup tasks. • Charge the device (Charging the Device, page 1).
3 Place a rubber pad around the seat post, if necessary: • If the seat post diameter is 27 to 28.6 mm, use the thicker pad. • If the seat post diameter is 30.4 to 31 mm, use the thinner pad. • If the seat post diameter is 31 to 31.8 mm, do not use a rubber pad. Place the seat-post connector around the rubber pad. 4 NOTE: You should align the contours on the rubber pad with the grooves on the inside of the seat-post connector. 5 Replace and tighten the screw.
Device Settings You can remotely control your Varia devices and customize settings using your compatible Edge device. This section contains instructions for the Edge 1000 device. Other compatible Edge devices use similar settings. Pairing Varia Bike Lights with Your Edge 1000 Before you can pair the devices, you must update the Edge software. 1 Bring the Edge device within range (3 m) of the sensor. NOTE: Stay 10 m away from other ANT+ bike lights while pairing. 2 Turn on the Edge device.
À Taillight key. Select to signal a left turn when using two taillights. Hold to cycle through the taillight intensity and pattern modes. Á Headlight key. Select to switch between low beam and high beam. Hold to cycle through the headlight intensity and pattern modes. Â Ã Taillight key and power key. Select to signal a right turn when using two taillights. Hold to turn all lights on and off. Status LED. Status LED 3 Select the left or right turn signal.
Never put batteries in mouth. If swallowed, contact your physician or local poison control center. Replaceable coin cell batteries may contain perchlorate material. Special handling may apply. See www.dtsc.ca.gov /hazardouswaste/perchlorate. CAUTION Contact your local waste disposal department to properly recycle the batteries. Before you can replace the battery, you must have a small Phillips screwdriver, a small flat screwdriver, and a CR2032 lithium coin-cell battery.
Radio frequency/protocol 2.4 GHz ANT+ wireless communications protocol Water rating 5 ATM* *The device withstands pressure equivalent to a depth of 50 m. For more information, go to www.garmin.com/waterrating. Device Care NOTICE Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause permanent damage. Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes.
Index A accessories 6 B bands 6 battery charging 1 life 4 replacing 4 C cleaning the device 6 customizing the device 3 D device, care 6 E Edge 3, 4 G Garmin Express registering the device 6 updating software 6 I installing 1, 2 K keys 2, 4 M maps, updating 6 mounting the device 1, 2, 4 O O-rings.
www.garmin.