Installation & Assembly

ASSEMBLY INSTRUCTIONS

Chimenea Stands S2 & S3 K/D

Please follow these instructions for the correct assembly of your chimenea stand.

The stand has the following components:

1 x Ring

3 x Legs

3 x Hex socket screws

1 x hex key

Assembly is best done by placing all the components on a table.

1.0 Place the ring with the sockets pointing upwards. Pickup a leg and locate

the flat on the straight part. Insert the leg into the socket so that the feet are

pointing inwards.

2.0 Insert one hex socket screw into the threaded hole in the ring leg socket

And tighten using the fingers. Check the feet are pointing inwards and the screw

is contacting the ‘flat’ on the top of the leg.

3.0 Repeat the above procedure for all three legs. The assembled stand

should now look as shown below-

WARNING: tighten all screws using the hex key, If the screws are not tight

there is a risk of a leg becoming detached and the stand collapsing.

PAGE 1
ASSEMBLY INSTRUCTIONS Chimenea Stands S2 & S3 K/D Please follow these instructions for the correct assembly of your chimenea stand. The stand has the following components: 1 x Ring 3 x Legs 3 x Hex socket screws 1 x hex key Assembly is best done by placing all the components on a table. 1.0 Place the ring with the sockets pointing upwards. Pickup a leg and locate the flat on the straight part. Insert the leg into the socket so that the feet are pointing inwards. 2.
PAGE 2
INSTRUCTIONS D’ASSEMBLAGE POUR SUPPORTS DE CHEMINEE S2 & S3 K/D SVP suivez-ces instructions pour assembler correctement votre support de cheminée. Voici les composants de votre support : 1 x cercle 3 x pieds 3 x vis six pans 1 x clé six pans L’assemblage est mieux réalisé en plaçant tous les composants sur une table 1.0 Placez votre cercle avec les trous vers le haut. Placez votre pied avec la partie plate sur la partie rectiligne du trou.