User's Manual

ManualsBrandsGaon-Int ManualsElectronics2.4GHz RF Wireless Presenter

i – POINTER

Wireless RF Presenter

User Manual

CAUTION

Use of controls or adjustment or performance

of procedures other than those specified herein

may result in hazardous radiation exposure

WARNING:

Never look directly into the laser beam.

Never Point a laser beam at a person.

Keep out of reach of children.

Composition: RF Transmitter / Receiver / AAA Battery / Carrying Case / User Manual

FUNCTION

KEY BUTTON

Long Click

- Slide start

- Slide finish

Short Click

- Black screen

PAGE UP

BUTTON

PAGE DOWN

BUTTON

LASER BEAM

BUTTON

Summary of content (5 pages)

PAGE 1
i – POINTER Wireless RF Presenter User Manual FUNCTION KEY BUTTON PAGE UP BUTTON Long Click PAGE DOWN BUTTON - Slide start - Slide finish Short Click - Black screen LASER BEAM BUTTON CAUTION Use of controls or adjustment or performance of procedures other than those specified herein may result in hazardous radiation exposure WARNING: Never look directly into the laser beam. Never Point a laser beam at a person. Keep out of reach of children.
PAGE 2
Thank you for choosing the i-POINTER For proper use please read the enclosed instructions carefully. QUICK INSTALL GUIDE 1. Install the provided battery on the Remote Controller. 2. Insert the Receiver into the USB port. 3. LED light on the Receiver starts blinking. Press “Up” or “Down “ button on the Remote Controller for two seconds until LED light becomes steady OFF, The blink works when push the buttons. 4. Open MS PowerPoint.
PAGE 3
Battery change Use 1.5V AAA battery 1 EA 1. Slide clip upward to open the battery cover. 2. Replace the battery. Pay attention to the polarity. 3. Slide the cover back into the position until it clicks. 4. Check if the laser pointer functions properly. Setting up the i-POINTER 1. Install the battery on the Remote Controller. 2. Insert the Receiver into the USB Port 3. The i-POINTER is installed automatically and will work after it is inserted into the USB Port. 4.
PAGE 4
5. Open MS PowerPoint. Check the operation by pressing [c] and [d] buttons on the Remote Controller. PowerPoint frame should move forward or backward after pressing the button. 6. Press Long-Click of Side button, Slide start of MS PowerPoint and finish with press again and press-short click of Side button, it becomes Black screen for conversation time. Specification Remote Controller : IP-100 Range of Operation 100 ft. Buttons 4 (1 for laser beam, 3 for PowerPoint control) Battery 1.
PAGE 5