Data Sheet

ManualsBrandsGanz ManualsElectronics16Ch 15W Ethernet over UTP Extender w/Pass-Through PoE

FEATURES

› Transmits individual Ethernet data channels with Pass-through

PoE over standard UTP or Coaxial cable

› Extends Ethernet up to 3,000 feet (914 m) at 10 Mbps or

2,000 feet (610 m) at 100 Mbps over UTP cable

› Extends Ethernet up to 5,000 feet (1,524 m) at 10 Mbps or

2,000 feet (610m) at 100 Mbps over Coaxial cable

› Extended temperature operation from -40°C to +75°C

› Extended Pass-through PoE meets the IEEE 802.3af standard

for Power over Ethernet

› Full 10/100 Mbps Bandwidth

› Supports Multicast, Unicast and Jumbo Frame

› Symmetric Bandwidth provides consistent upload and download

with virtually zero packet loss over the total usable distance

› Type tested to RFC-2544 TCP/IP network bandwidth packet

transmission standards

› User-selectable data rate for maximum bandwidth and

transmission distance utilization

› Complies with all major IEEE standards and RFC network

protocols for UDP, TCP/IP, HTTP/HTTPs

› Tested and certified* by an independent laboratory for full

compliance with the environmental requirements (ambient

operating temperature, mechanical shock, vibration, humidity

with condensation, high-line/low-line voltage conditions

and transient voltage protection) of NEMA TS-1/TS-2 and

CALTRANS Traffic Signal Control Equipment Specifications.

› Designed and manufactured in the USA

› LED status indicators confirm operating status

› Available in small-size, interchangeable stand alone, or 1RU

high rack mounted models

› Lifetime warranty

APPLICATIONS

› Retrofit existing analog CCTV installations to Ethernet-

based systems

› CCTV systems for casinos, airports, school campuses

The Ganz™ Ethernet over copper line supports up to sixteen channels of

10/100Mbps Ethernet with Pass-through PoE over twisted pair cable (CAT-5,

UTP), or over coaxial cable. The single channel units may be powered by a

PoE switch or the included power supply. Four, eight, and sixteen channel units

operate from local power. These units provide the ultimate flexibility for extending

a powered device (PD) over long distance copper. DIP switches are provided

for user-selection of local or remote, 10 or 100Mbps, and 1 pair or 4 pair (UTP)

settings.

GLFE(X)EO(C,U)

Ethernet-over-Copper Extender With Pass-Through PoE

EXTENDER PASS-THRU

HARDENED

* One Channel Units Only. Multichannel units are designed to meet NEMA TS-2 Spec.

Summary of content (3 pages)

PAGE 1
Ethernet-over-Copper Extender With Pass-Through PoE GLFE(X)EO(C,U) HARDENED EXTENDER PASS-THRU The Ganz™ Ethernet over copper line supports up to sixteen channels of 10/100Mbps Ethernet with Pass-through PoE over twisted pair cable (CAT-5, UTP), or over coaxial cable. The single channel units may be powered by a PoE switch or the included power supply. Four, eight, and sixteen channel units operate from local power.
PAGE 2
Ethernet-over-Copper Extender With Pass-Through PoE GLFE(X)EO(C,U) SPECIFICATIONS Ethernet Mechanical Data Interface 10/100BaseT(X) Ethernet Data Rate DIP-switch selectable 10/100Mbps Full data rate / full duplex up to the maximum rated distance RFC 2544 TCP/IP Packet Transmission Standards IEEE 802.3af PoE, RFC: 768 UDP, 2068 HTTP, 793 TCP 791 IP, 1783 TFTP, 894 IP over Ethernet. Transmission Distances1 See chart below Current Protection Circuit Board Meets IPC Standard Size (L×W×H) 1 CH: 3.
PAGE 3
Ethernet-over-Copper Extender With Pass-Through PoE GLFE(X)EO(C,U) MAXIMUM TRANSMISSION DISTANCES1 Media COAX - RG59/U Data Rate UTP - 4 pair 10M Source Power 100M 15W 30W 10M 15W 5,000 ft 1,524 m Non-PoE Max.Distance1 UTP - 1 pair 30W 100M 15W 2,000 ft 610 m 30W 10M 15W 3,000 ft 914 m 30W 100M N/A 2,000 ft 610 m 3,000 ft 914 m 1,000 ft 305 m PoE CLASS2 (6.