User guide

Page 1 of 1
GAM Product # TS6200
Rosco Product # 206 36000 0000
PRODUCT INSTRUCTIONS
www.rosco.com
1. You will need one Phillips Screwdriver.
(Go get it. We’ll wait here).
2. Place your completely assembled ETC Source IV in
front of you. Using the Phillips screwdriver, remove the
Barrel Rotation Knob and the Retainer Bolt from the Barrel
Assembly. These two pieces are located roughly in the
middle of the instrument, on the top and bottom, just be-
tween the shutters and the yoke. Place the Barrel Rotation
Knob and the Retainer Bolt in a secure place that you’ll
remember. You will need them again in just a moment.
3. Rotate the Barrel so that it disengages and comes
away from the lamp housing. You should now have two
separate pieces. Completely unscrew the Beam Focus
Knob and remove it from the Barrel Assembly. Slide your
Lens Tube out of the Barrel and place the Barrel Focus
Knob inside the Lens Tube for safekeeping. Place your
now empty Barrel on a storage shelf and say goodbye
for now. You will not need it again until you are finished
using your SX4®.
4. Place your SX4®, Barrel side down, on the table.
Place the top of your ETC Source IV over the SX4® and
gently rotate until the two pieces engage. As you do this,
make sure you have it adjusted for the angle you wish to
project with our effect unit. (Either 90º or straight on, de-
pending on the loop design and/or your hang position)
SX4
®
case attaches here
(replaces barrel)
Retainer bolt
Barrel knob
Barrel
Remove Barrel
Lens Tube
5. Replace your Barrel Rotation Knob and your Retainer
Bolt into the appropriate fittings. If you are using the SX4®
unit in the standard, “straight on” position, you will find
it necessary to place the Retainer Bolt on the bottom of
the unit, where the Barrel Rotation Knob would normally
attach. This is because the fan housing on the SX4® and
the larger Barrel Rotation Knob impede each other.
6. Tighten down both bolts to secure the SX4® housing
into the Reflector Housing. Slide the Lens Tube into the Bar-
rel of the SX4® and secure it with the Beam Focus Knob.
(Told you not to misplace it!) Now your SX4® effect pro-
jector is ready to be placed in its hanging position.
7. When you have finished using the SX4®, it can be re-
moved from the Source IV Reflector Housing, and the Source
IV can be reassembled, using the above steps again.
SX4® INSTALLATION