Installation Instructions

Long press the set
button for 3 seconds
Long press the set
button for 3 seconds
Press the up button
on the remote
The indicator flashes
3 times then goes out
The indicator flashes
3 times then goes out
The indicator flashes
3 times then goes out
The indicator flashes
3 times then goes out
The motor is in the
setting state
the motor is in the
setting state
Indicator
Extended Port
Extended setting Button
Setting
Button
the motor is in the
setting state
press the setting
button once
Release the button when
the indicator is bright
Done
Done
Done
Done
Reverse Settings
FCC Warning
The setting state goes out
within 10 seconds if there is
no other operation !
It is effective only when
the the remote in use has
been learned!
Press the down button
on the remote which
has been learned
The working direction
of all the control will be
reversed after setting!
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception, which can be determined by turning the
device off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the device and receiver.
--Connect the device into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment