JIB/BT8R USER’S MANUAL Stereo Bluetooth Receiver €) Bluetooth’ >> GALAXY AUDIO MAKERS OF THE ORIGINAL POTSHOT PERSONAL MONITOR
career cert ere 1 cr err rear enter 2 System IEEE rise ceases ere rer Mennen ee anon en 2 JIB/BT8R Receiver Feature sand Functions... 3 Receiver Setup... 4 Bluetooth Pairing and 5 Specifications... ree 8 Thank you for choosing the Galaxy Audion professional, lightweight, compact, portable Stereo Bluetooth Receiver.
IMPORTANT SAFETY INSTRUCTIONS | 1. READ these Instructions. 10. PROTECT the pwr ond fom belong walked on or arched. party of pugs, 2. KEEP theses Instructions. ‘convenience receptacles, and the point whets they exit from the apparatus. 3. HEED all wakings. 11. ONLY USE attachmentsiaocsesorles specified by the manufacturer. 4. FOLLOW all instructions. 12. UNPLUGGING bis spare ding hing soar cr when used or long prods of 5. DO NOT se this apparatus near water. 6. CLEAN ONLY with diy cloth.
JITTERBUG Stereo Bluetooth Receiver Receiver Features: Front Panel Back Pane! (3) 2.4 GHz Antenna Connector (8) Volume Control @ Euro-block Connector [O] 5 DCA Power Input Status LED (7) L/R XLR Balance Output (4) Bluetooth Pairing Button -LIR 1/4" Balance Output Receiver Functions: 1. ANT: Connect ths included removable 2.4 GHz antenna. The antenna receives and transmits the Bluetooth signal from a paired Bluetooth device. The JIB/BTSBR has a range melees under optimal conditions. 2.
System Setup Connecting Cables From JITTERBUG Receiver Outputs 1. Connecting XLR Cables: Plug XLR cables to the XLR balanced L/R outputs on the JIBBING. Connect the other ends of the XLR cabals to the XLR RL inputs of a mixer, active speaker, or amp. 2. Connecting 1/4” (6.35mm] Cables: Plug 1/4" (6.35mm) cables to the 1/4" balanced L/R outputs on the JIB/BTSR. Connect the other ends of the 1/4" cables to the 1/4" RIL inputs of a mixer, active speaker, or amp. Final Setup Connections 1.
Wireless Paling Setup 1. Make Sure The Receiver Is Powered On: If the receiver is not yet powers on, connect the included power adapter to connect JITTERBUG 8V DOHA Input. Connect the other end to your power source. HOT: The "STATUS" LED will quickly flash red and green while unpaired. 2. Ready Your Bluetooth Enabled Device: Make sure your Bluetooth enabled device has its Bluetooth feature muted on and is within range. 3.
Specifications Bluetooth Version: V4.0 Frequency Range: 2.4GHz 2 GHz Output Connector: Left/Right Balanced XLR/M, Left/Right Balanced 1/4" Line Controls: Volume, Wireless Bluetooth Pair, Remote Pairing Euro-block Connector Indicators: Status LED Sensitivity: -DBMS < BER Signal to Noise: >75dB Total Harmonic Distortion: <0.1% Operating Range: Under Typical Conditions 32.8 (1om) Mote: actual ranges depends on RF signal absorption, reflection, and interference.
S> GALAXY AUDIO MAKERS OF THE ORIGINAL HOT SPOT PERSONAL MONITOR THREE YEAR LIMITED WARRANTY WARRANTY Information can be viewed online at HTTP: JIB/BT8R USER'S MANUAL Specifications in this manual are subject to change without notice. For the most up fo date manual and information visit www galaxyaudio.com. 1-800-369-7768 www.galaxyaudio.