User’s Guide SAGA1-P40 Joystick type Industrial Radio Remote Controller Gain Electronic Co., Ltd.
Warning and Caution The following symbols may be found on the product or throughout the documentation. Symbol Description Refer to Manual Refer the user manual for additional information when product marked with this sign. Dangerous Voltage Indicates presence of hazardous voltage. Unsafe practice could result in severe personal injury. Warning Denotes a hazard. Included text gives proper procedures. Failure to follow instructions could result in severe personal injury and/or property damage.
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. (3) Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Chapter 1. Limited Warranty Warranty Gain Electronic Co., Ltd. guarantees that this equipment meets its published specifications at the time of shipment from the factory. This equipment will perform as described if installed properly. However, Gain cannot guarantee that operation in SAGA product is absolutely error‐free, or without interruption. Warranty Period This equipment is warranted against defects in materials and workmanship for a period of one year from the date of shipment.
2‐2 Procedures of emergency: In case of an Emergency, please follow the steps below and ask the distributor for service immediately. ¾ Press EMS button. ¾ Turn the “rotary key” to “OFF” position and remove it. ¾ Switch off the main power of crane. ¾ Advise the distributor to check it out. Chapter 3. Operation 3‐1.
3‐2. SAGA1‐P40 Receiver Wiring Diagram of Control Contact Cable Assemble #2 Cable Assemble #1 3‐3. General Operation 1. Turn on the main power switch of the equipment (Crane). 2. Install four AA size batteries in the transmitter make sure the “+”and “‐” direction are correct. 3. Rotate “EMS” mushroom clockwise 45לand pull out. 4. Turn the rotary key clockwise to "ON" position, then press the “Start” pushbutton to Power‐On. 5. Operate normally according to the function setting has done. 6.
3‐4. Receiver Voltage Selections There are four input voltages available for the SAGA1‐P40 as follows: 48/110VAC 48/220VAC 110/220VAC 220/380VAC. Please disconnect the Rx’s power, select the proper voltage and plug in the connector.