User’s Guide SAGA1-L40 Joystick type Industrial Radio Remote Controller 8 1
Contents Warranty Precautions of operation General Operation Batteries Emergency Procedures Wiring 8 2
Warranty Gain Electronic Co., Ltd. guarantees that this equipment meets its published specifications at the time of shipment from the factory. Under proper installation it should work as expected. However, GAIN does not guarantee that operation in SAGA1 system is error free or without intermission. This equipment is warranted against defects in material and manufacturing for a period of one year from the date of shipment.
Precautions of Operation 1. Please carefully read the manual before operating this device. 2. Never dismantle the equipment by any unauthorized personnel, or equipment may be damaged. 3. This manual is for reference only. Pleases consult your distributor for further assistance. 4. The equipment has been strictly tested for quality before delivery from our plant. However, this equipment must not be used in dangerous situations or where damage may result. 5.
General Operation 1) Turn on the main power switch of the equipment (Crane). 2) Install four AA size batteries in the transmitter make sure the “+”and “-“ direction are correct. 3) Turn the rotary key switch clockwise to "ON" position, then press the Start pushbutton to Power-On. 4) Operate normally according to the function setting has done.
Emergency Procedures In case of any emergency, please follow the steps below and ask the distributor for service immediately: 1. Press EMS mushroom. 2. Turn the rotary key to "OFF" position. 3. Shut off the main power of the Crane and discontinue the operation. 4. Contact the distributor to find out reasons.
Batteries Four AA size batteries are required for the transmitter. There is a 3-stage power indicating functions with LED display. “Green color”: Sufficient power to operate transmitter. ”Yellow color”: Power is depleting. Operation must be stopped immediately (for example: down the goods to ground) to replace batteries. “Red color”: Insufficient power. Transmitter will send out an emergency stop signal to the receiver due to insufficient power.
6 Wiring 6
FCC Caution: 1. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. 3.