User Manual

Installation and User Instructions for S830 Readers

Model number:S830-HICLR

The S830 is a small-footprint 125kHz proximity card

reader that is capable of reading HID format cards.

The S830 uses p

20mA current loop seudo-random

communications

Mount the Backplate

To mount the backplate:

1) Detach the main body of the reader from the

backplate by inserting a fingernail into the groove in

the bottom edge of the reader and swinging the

reader upwards.

2) Mount the backplate adjacent to the opening edge

of the door and at a convenient height. Feed the

cable to the reader through the backplate.

PAGE 1
Installation and User Instructions for S830 Readers Model number:S830-HICLR The S830 is a small-footprint 125kHz proximity card ® reader that is capable of reading HID format cards. The S830 uses 20mA current loop pseudo-random communications. 1 Mount the Backplate To mount the backplate: 1) Detach the main body of the reader from the backplate by inserting a fingernail into the groove in the bottom edge of the reader and swinging the reader upwards.
PAGE 2
Reader Connections 20mA Current Loop Reader Connections Controller connections (20mA reader port) 0V Rx+ RxTx+ Tx- Connect screen at controller end only (attach to case) 3 Red Black Green Orange White Blue 12V 0V Tx+ Tx- Reader 12V Rx+ Rx- Note: the brown wire is not used Using the Reader Present the proximity card face-on to the reader until you hear a "bleep". The maximum read range is typically 2.5" (65mm). If the green indicator is lit, the card has been accepted and the door is unlocked.