User's Manual

Installation and User Instructions for S822 Encoders

Cable Connection

The S822 encoder is used to encode

blank HID i smart cards to

the "smartMAX" format, or to re-

encode existing "smartMAX" format

i cards.

CLASS

TM®

Insert the jack plug

into the box on the

end of the encoder

cable.

Insert the power

plug into

the box on

the end of the

encoder cable

Connect the 12Vdc

power source to the

mains supply.

Connect this RS232-to-

RS485 converter to a

serial port of a PC

installed with the SMS

software. Set up the port

in the Install/Client Ports

screen of the SMS

software.

PAGE 1
Installation and User Instructions for S822 Encoders The S822 encoder is used to encode ® TM blank HID iCLASS smart cards to the "smartMAX" format, or to reencode existing "smartMAX" format iCLASS cards. 1 Cable Connection Insert the jack plug into the box on the end of the encoder cable. Insert the power plug into the box on the end of the encoder cable. Connect this RS232-toRS485 converter to a serial port of a PC installed with the SMS software.
PAGE 2
Encoding Procedure To encode a card: 1. Log in to the SMS software at the PC that the encoder is connected to. 2. Start the encoding procedure from the appropriate screen in the SMS software. For example, if you are using a standard client, use the Encode button in the Card Holders screen. 3. When prompted, present the card to the encoder. You will hear a "bleep" when the card has been encoded. LEDs: Red - Lit when power is supplied to the encoder. Green - Lit when the encoder has received data.