OM247-SOLO Safety Guide User Safety and Regulations Document Classification: Public
About This Guide This guide contains basic regulatory and safety information. Document Number: 94-0159-01 Revision: 1.
User Safety Operational Warnings Important information on safe and efficient operation. Read this information before using the device. For safe and efficient use of the device, observe the guidelines outlined below. International Protection Rating The device carries an IP rating of IP68 and as such can be immersed in water up to a depth of 5 metres.
Product Handling Do not disassemble, open, crush, deform or puncture the product. Do not modify, remanufacture, attempt to insert foreign objects, expose to fire, explosion or other hazards. Only use the product with an approved charger. Use of an unqualified charger may present a risk of fire, explosion, leakage or other hazard. Use only approved power accessories such as AC-power adaptors.
FCC Statements This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Statements (continued) Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
EU Regulatory Conformance We hereby declare that this device is in conformance to all essential requirements of the R&TTE Directive 1999/5/EC. This equipment is marked with the ‘CE’ symbol and can be used throughout the European Community. This indicates compliance with the R&TTE Directive 1999/5/ EC and meets the relevant parts of the following technical specifications: ETSI EN 300 220-1 V2.3.1 ETSI EN 300 220-2 V2.3.1 ETSI EN 301 489-1 V1.8.1 ETSI EN 301 489-3 V1.4.
RF Safety Exposure (SAR) This unit has been tested for RF exposure compliance at a qualified test laboratory. It was found to comply with the regulations regarding exposure to RF Energy under the recommendations of the International Commission on Non-Ionizing Radiation Protection (ICNIRP). SAR (Specific Absorption Rate) is measured using the device’s highest transmitting power.
