OM247-FIT Fitting Tool & Key Fob Safety Guide User Safety and Regulations Document Classification: Public
About This Manual This guide contains basic regulatory and safety information. Document Number: 94-0175-01 Revision: 1.
User Safety Operational Warnings Important information on safe and efficient operation. Read this information before using the device. For safe and efficient use of the device, observe the guidelines outlined below. Environmental Specification 10% to 90% relative humidity Operational Temperature range -20°C to +60°C (AC Power Adaptor: RH 20% to 85%, Operating Temperature 0 to 40°C) Operation The equipment must be used by a SERVICE PERSON.
Product Handling Do not disassemble, open, crush, deform or puncture the product. Do not modify, remanufacture, attempt to insert foreign objects, expose to fire, explosion, or any other hazards. Only use an approved AC power adaptor with the Fitting Tool. Use of an unapproved charger may present a risk of fire, explosion, leakage or other hazard.
FCC Statements This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Statements (continued) Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
EU Regulatory Conformance We hereby declare that these products are in conformance to all essential requirements of the R&TTE Directive 1999/5/ EC. The products are marked with the ‘CE’ symbol and can be used throughout the European Community. This indicates compliance with the R&TTE Directive 1999/5/ EC and meets the relevant parts of the following technical specifications: EN 301 489-1 v1.6.1:2005 EN 300-220-2 v2.1.