G4S PID3 User Operation Manual Version 1.01 Last Updated: Dec 3, 2010 This document contains information proprietary to G4S. Any disclosure or use of this information or any reproduction of this document for other than the specific purpose for which it is intended, is expressly prohibited except as G4S may otherwise agree to in writing.
G4S PID3 User Operation Manual Document Revisions Revision Date 1.
G4S PID3 User Operation Manual Contents 1. INTRODUCTION .................................................................................................................................... 3 2. GENERAL OPERATIONAL DESCRIPTION ........................................................................................ 4 2.1 NETWORK SETUP MODE............................................................................................................... 4 2.2 STRAP SETUP MODE .....................................
G4S PID3 User Operation Manual 1. INTRODUCTION This document describes operation of the G4S PID3 device from an end‐users perspective. The PID3 device is one piece of the Longitude offender GPS tracking system and is designed to communicate with a G4S Longitude GPS device (hereon referred to as the “GPS” device). Detailed description of the operation of the GPS device is covered in a separate manual.
G4S PID3 User Operation Manual encrypted messages with a unique key for each such GPS/PID3 network. This allows multiple GPS/PID3 paired devices to co‐exist. 2. GENERAL OPERATIONAL DESCRIPTION 2.1 NETWORK SETUP MODE The PID3 device will be in an “OFF” state when in storage wherein it will not be transmitting (or receiving) any radio messages. When it is to be installed on an offender, it will need to be turned on using the “ON” key on an Officer Key Fob (OKF) device.
G4S PID3 User Operation Manual NOTE: The user must ensure that the GPS device is correctly set up with the PID3 serial number that it needs to be paired with before the PID3 can successfully attach to the GPS devices network. To configure the GPS device with the PID3 Serial Number that it needs to be paired with, a configuration command must be sent from the monitoring centre to the GPS device.
G4S PID3 User Operation Manual 2.4 LOSS OF CONTACT BETWEEN PID3 AND GPS DEVICE If the GPS device does not receive any STATUS message from the PID3 device for a specified “PID_LEAVE_TIME” interval (typically 5 minutes), it logs an event indicating that it has lost contact with the PID3 and reports this event to the monitoring centre.
G4S PID3 User Operation Manual Shutdown_SN: This is the serial number of the Officer Key Fob or the serial number of the GPS device that was used to shutdown the PID3. MainBattVolts: This is a value representing the PID3 main battery measured voltage. VibeBattVolts: This is a value representing the PID3 vibrator battery measured voltage. MainBattCount: This is a number representing the amount of main battery capacity already consumed by the PID3 device since the date of manufacture.
G4S PID3 User Operation Manual 3.
G4S PID3 User Operation Manual 4. Regulatory Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.