User's Manual

ManualsBrandsG.Tech Technology ManualsComputers & AccessoriesWireless Keyboard

- 1-

RF Wireless Slim Keyboard (K1902) and Mouse

Desktop Instruction Manual

Version: GT3.0

The wireless keyboard and optical mouse operate with digital radio technology. There is no

connecting cable to pile up desktop. The keyboard and mouse use radio frequencies to

send data to the receiver, which forwards these to your computer. You can use the

keyboard and mouse on any computer equipped with a free USB interface. There are two

channels, CH1 and CH2 for your selection.

CE marking

This equipment complies with the requirements of Directive 1999/5/EC of the European

Parliament and Commission from 9 March 1999 governing Radio and Telecommunications

Equipment and mutual recognition of conformity.

BATTERY INSTALLATION

The cordless optical mouse uses two AAA rechargeable batteries.

pic.1

1. Press the tab to remove the battery

compartment cover on the bottom of the

mouse.

2. Insert two supplied AAA rechargeable

batteries in the battery compartment

according to the polarity marked inside.

3. Replace the cover.

The cordless keyboard uses two AAA batteries.

pic.2

1. Press the tab to remove the battery

compartment cover on the bottom of the

cordless keyboard.

2. Insert two AAA batteries(MAXELL) according

to the polarity marked inside.

3. Replace the cover.

Summary of content (10 pages)

PAGE 1
RF Wireless Slim Keyboard (K1902) and Mouse Desktop Instruction Manual Version: GT3.0 The wireless keyboard and optical mouse operate with digital radio technology. There is no connecting cable to pile up desktop. The keyboard and mouse use radio frequencies to send data to the receiver, which forwards these to your computer. You can use the keyboard and mouse on any computer equipped with a free USB interface. There are two channels, CH1 and CH2 for your selection.
PAGE 2
BATTERY NOTES Dispose of old batteries promptly and properly. Do not burn or bury batteries. Use only fresh batteries of the required size and recommended type. Do not mix old and new batteries, different types of batteries (standard, alkaline or rechargeable), or rechargeable batteries of different capacities. If you do not plan to use the mouse or the keyboard for more than a week, remove the batteries. Batteries can leak chemicals that may damage electronic parts.
PAGE 3
SETTING UP THE ID WIRELESS LINK Set up your Keyboard and Mouse ID wireless link separately. Slim Keyboard 1. Press CONNECT key on the receiver after booting the system. The green LED inside the connect key will light on. 2. To set up the keyboard wireless link, press CONNECT key on the bottom of the slim keyboard. The green LED will go off. pic.3 Optical mouse 1. Press CONNECT key on the receiver after booting the system. The green LED inside the connect key will light on. 2.
PAGE 4
is as bellows: For mouse to set channel If you decide to use “CH 1” for mouse, 1. Remove the battery compartment cover on the mouse, turn the button inside the compartment to “ CH 1 “ and replace and close the cover. 2. Press the “ CONNECT “ key on the receiver. 3. Press the “CONNECT” key on the bottom of the mouse. Then the CH1 can be set successfully. Note: the same way for “ CH 2 “ setting. 1 A Pic5 For keyboard to set channel The channel of keyboard can be detected automatically.
PAGE 5
The operation is same as that SETTING UP THE ID WIRELESS LINK BATTERY LOW WARNING On the Mouse The mouse has a battery-low indicator, which will light RED when battery has low power. Low power indicator On the Keyboard Pic7 When you press any key, the power indicator & on the keyboard lights RED to show the keyboard batteries are out of power.
PAGE 6
Notes: Do not use non-rechargeable batteries; only use rechargeable batteries. The recharge power is available while the computer is powered off if the input electricity is available. Be sure the indicator lights red when charging the batteries. SOFTWARE INSTALLATION Note: Before installing the software, in order to achieve a successful installation, please uninstall other wireless mouse and keyboard drivers first.
PAGE 7
Using Your Mouse The mouse has five buttons: left button, right button, mid-button, fourth and fifth buttons. The mid-button (wheel) functions both as a wheel and a button, which can be used as a button or for scrolling, e. g. in documents or on Internet pages. For scrolling in documents, roll the wheel forward or backward. Right button 2nd button Wheel button 3rd button To use the wheel like a standard mouse button, click on the wheel.
PAGE 8
the software’s online help. Outside the Internet browser, the keys have the standard functions. Increasing the volume This key increases the volume of the connected loudspeakers. Decreasing the volume This key decreases the volume of the connected loudspeakers. Switching the loudspeakers on/off Use this key to switch on/off the connected loudspeakers. Calculator Use this key to active the calculator software in your system. E-Mail Use this key to start the standard e-mail programme for your system.
PAGE 9
2. Make sure the batteries have enough power, See BATTERY LOW WARNING. 3. Make sure the receiver is correctly connected. See CONNECTING THE RECEIVER. Set the communication code once more See SETTING UP THE ID WIRELESS LINK. 4. Disconnect the cable between the receiver and the computer, and then reconnect it. Mouse Not Detected 1. For optimal performance, place the receiver at least eight inches away from other electronic devices, such as the computer monitor or external storage drives. 2.
PAGE 10
CAUTION To avoid interference with an aircraft's electronic systems, do not use your wireless desktop during a flight. Make sure you have removed the batteries from your wireless keyboard and mouse. Only complied LPS AAA alkaline battery can be used. Caution: Risk fo explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Only Brand "MAXELL" battery can be used.