GENEVA Cinema Manual for: Geneva Cinema / Product Nr: A040 Geneva Cinema - Manual Page
CHANGE: (in batteries): CR2025 -> CR2032 Geneva Cinema - Manual Page
Licensing information Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of G-Lab GmbH Geneva® is a registered trademark of G-Lab GmbH. Apple , iPod, iPhone and iPad are trademarks of Apple Computer, Inc. registered in the U.S. and other countries. The Bluetooth® word mark and logos are registered Trademarks owned by Bluetooth SIG, Inc. © 2014 G-Lab GmbH. All rights reserved. The EmbracingSound® trademark is owned by Embracing Sound Experience AB.
Getting Started About the Geneva Cinema The Geneva Cinema supports the following sources: - TV audio inputs (analog and digital audio) - Bluetooth - Additional audio input for external devices The Geneva Cinema has the following built-in functions: - Automatic selection of the three different TV audio inputs - Automatic power-on and off - Automatic adaption of the audio volume using Total Volume® - Voice enhancement - Very wide stereo reproduction You can connect your TV using the following connectors: - An
Using the Geneva Cinema Remote control Power On / Off Volume control Bass control Treble control Voice enhancement on / off Total Volume® on / off Bluetooth Mute Line In TV (automatic input selection) Manually selecting TV inputs (hold 3 sec.
Connector AC power input TV audio input / Analog TV audio input / Coaxia TV audio input / Optical Line In Details 100 - 240 V AC, 50/60 Hz Analog audio input (stereo), RCA connectors Digital audio input (stereo), coax/SPDIF Digital audio input (stereo), optical/TOSLINK Analog audio input (stereo), 3.5mm connector TV Press TV on the remote control to listen to audio from the TV. The Geneva Cinema selects automatically the correct audio input from the three different TV inputs.
- Loud commercials: many commercials have an higher average volume that the regular TV program. With TotalVolume you don’t need to adjust the TV volume before and after commercials. - Movies: when watching a movie from a DVD or Bluray, the audio is edited for movie theaters. This means the differences between quiet and loud passages are very high. With TotalVolume you don’t need to adjust the volume during the movie.
LINE IN The Geneva Cinema has a line-in input (3.5mm, stereo connector) for external audio devices. 1. Connect one end of a Line-In cable to the Line-In connector at the back of Geneva Cinema Then connect the other end of the cable to the audio device (headphone or Line-Out connector). 2. Press LINE-IN on the remote control.
TV SETUP Overview 1. Check your TV’s audio output. Depending on the available connector, select one of the three methods. 2. The TV setup is very easy: the Geneva Cinema will select automatically the correct TV inputs. 3. To change the audio output from your TV’s speakers to its audio output connector, you need to select this on your TV’s menu by selecting “External Speakers”. A. TV with digital audio output (optical/TOSLINK) To set it up: 1.
TROUBLESHOOTING GENERAL How do I clean the speaker cabinet? The cabinet can be cleaned with a water soaked cloth. Use only a microfiber cloth. Do not use household paper, because it can contain glass fiber which can leave scratches. Light soap water can be used, but never hot water. If water cannot clean the stains, pure alcohol can be used. When cleaning, be careful around the logo and touch icon (control keys). Do NOT used alcohol around the logo and the touch icons, because alcohol will remove the them.
How to reset the Bluetooth Up to 8 paired Bluetooth devices can be stored. To clear the memory, perform the following steps: 1.Select Bluetooth with the remote control. 2.Within 5 seconds of entering Bluetooth mode, hold down the Bluetooth button until “RESET” displays. 3.Pair your mobile phone again.