User's Manual

11
Remote control
When the camera is on and the REMOTE CONTROL option is
enabled, the remote control allows you to take photos and videos
in the mode shown on the screen by pressing the START/STOP
button. Wireless range up to 40’.
Whenever the camera is on, the remote control will be automatically
synchronized when the START/STOP button is used to take a video or
photo. It is also possible to use only one remote control to control multiple
cameras.
Examples:
• When only one camera is on, the remote control automatically
synchronises to this camera when the START/STOP button is used to take a
video or photo.
• If multiple cameras are on, the remote control automatically synchro-
nizes to each camera when the START/STOP button is used to take a video
or photo. This means that the remote control will start recording or taking
photos simultaneously on each of these cameras.
POWER
The remote control must be powered by 2 lithium button
batteries LIR2032. Insert the batteries in the indicated
direction, the polarity of the battery must be respected
(+ upwards). DO NOT DISPOSE OF BATTERIES IN THE
GARBAGE.
HOW TO ATTACH THE REMOTE CONTROL
To attach the remote control using the velcro strap
(included), just insert the velcro strap into the slots on
each side of the back of the remote.
RECOMMENDATIONS
Do not submerge the remote control in the water.
FCC Notice: this device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Caution: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications or change to this equipment.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s):
Operation is subject to the following Two conditions:(1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.The
term “IC: “ before the certification/registration number only signifies that
the Industry Canada technical specifications were met. This product meets
the applicable Industry Canada technical specifications.