* Note: Please make sure that both the Main Unit and the Outdoor Sensor are power on within 3 minutes. If the Main Unit is powered for over 3 minutes without the sensor on, it will not pair with the Outdoor Sensor or receive signal anymore.
Instruction Manual Seven Keys: DOWN, MODE, SNOOZE/LIGHT, CHANNEL, UP, ALERTS, ALARM. 1. Display Unit • 12/24 h Time and Date.(Press “DOWN” key to switch) • Dual alarms. • Snooze function (snooze interval optional from 3 minutes to 20 minutes,default: 5 minutes). • RCC: WWVB(US) [ One product only have one RCC channel ]. • °C/°F switch over.(Press “UP” key to switch) • Weather forecast. • Indoor temperature range: 0°C-50°C (32°F-122°F), accurate range: ±1°C( ±1.8°F), display scope: 0°C - 50°C (32°F-122°F).
Tips: • The default channel of outdoor temperature sensor is "ChT'. Open the battery cover of sensor and remove the batteries can switch the channel. (The Outdoor Temperature Sensor) • Under cycle display mode, The display would show outdoor temperatures from connected channels cyclically. • If the indoor or outdoor temperature is out of the normal range, the low end displays "LL", the high end displays 3.
The weather station displays the following weather symbols: FORECAST FORECAST FORECAST → SUNNY FORECAST → SUNNY AND CLOUDY FORECAST FORECAST → FORECAST FORECAST → → CLOUDY FORECAST FORECAST FORECAST RAINY FORECAST → FORECAST → HEAVY RAIN SNOWY 3.6 RCC(Radio-controlled clock) Receiving Function Tips: To more accurately receive the WWVB radio, please place the station in a appropriate position.
3.7 UP KEY • Under time mode, press “UP” key to switch °C/°F display. • Under time, date, temperature alert, snooze mode, press “UP” key to go forward one step, press and hold “UP” key a few seconds to go forward 8 steps per second. • Under temperature alert mode, press “UP” key to turn alert on/off. 3.8 DOWN KEY • Under time mode, press “DOWN” key to switch 12/24H display.
(Snooze Interval Time Setting Display) • Press “Up” key, the value will go ahead 1 step, press and hold “UP” key for 2 seconds, the value will go ahead at an 8 step/second speed. • Press “DOWN” key, the value will go back 1 step, press and hold "DOWN" key for 2 seconds, the value will go back at an 8 step/second speed. • After setting, press “MODE” to exit. • If no key is press for 10 seconds to exit setting status, the value will stay. 4.
• Press “DOWN” key, the value will go back one step; press and hold for 2 seconds, the value will go back at an 8 step/second speed. After setting, press “ALERTS” to confirm. • If no key is pressed for 10 seconds, system will exit automatically to set status. 4.4 Tips • If powered by batteries, press any key or make a sound (greater than 60 decibels) to wake up the backlight (within 20CM).