Installation Instructions

ManualsBrandsFuzhou Smartreefs.Co ManualsElectronicsWifi auto top off

Manual

Smart A.T.O.

（WIFI Edtion）

System connection

Ver.1.0

** The water outlet should not be aligned with the probe.

*** If you unplug the power supply and still add water, it is

siphoning. You need to open a hole with a diameter of 1mm

on the water pipe. After opening the hole, water will flow

out of the hole and flow back into the bucket when the pump

is running,This is normal. After the pump stops working,

the small holes will draw in air and destroy the siphon.

Bucket

Fish tank

pump

Set-up Directions

1、Install the probe so that the water level is

at the lower edge of the probe.

2、Connect the probe, water pump and power

supply to the controller as shown on the left.

Step

If you quickly lower the water level or pick up

the probe during the test, it may be caused by

residual water droplets on the probe, the probe will

continue to sense that the water level is normal,As

long as the probe is cleaned, it will return to normal.

Magnetic

attraction

Pipe

rack

low level sensing point (Green)

High level sensing point (Yellow)

Water shortage (Lights oﬀ)

Meaning of the

indicator light

Because the system will calculate the appro-

priateamount of water according to the size of the

fishtank and generate the protection time, when

the fish tank is replaced,you must re-enter the

system setting interface to perform factory reset.

Notice

3、Refer to the networking instructions

on the back.

4、Test (Optional) ：pump out the water,

and then observe whether the system

will automatically add water back.

Initialization

If a siphon occurs,

punch holes in

this position.

The outlet pipe must not be lower

than the water surface, otherwise

the water will flow back from the

fish tank back to the bucket! !

Need to be cleaned

or avoid the sunlight

Prevent

siphon

Built-in wifi module

AUTOMATIC

AQUA DEVICE

← ← ←

→

←←

← ← ←

← ←

Smartreefs

Pause

Run

WIFI

Network button

Pause/resume

Fill up with

one click

Water level indicator

(Lights up when the probe detects water)

Probe

( Flashing red)

Power

supply

***

*When installing the probe, the wire on the probe must be vertically upward.

Smartreefs

Summary of content (3 pages)

PAGE 1
（WIFI Edtion） Manual Smart A.T.O. Ver.1.0 System connection The outlet pipe must not be lower than the water surface, otherwise the water will flow back from the fish tank back to the bucket! ! Set-up Directions Smartreefs Built-in wifi module AUTOMATIC AQUA DEVICE WIFI Water level indicator (Lights up when the probe detects water) Pause Run Fill up with one click Pause/resumeSmartreefs If a siphon occurs, punch holes in this position.
PAGE 2
Abnormal 5 In the case of inductive malfunctions and operational errors, such as water shortage in the bucket, water supply exceeding 2 cm, the system will stop and alarm with a flashing light. You can press the Pause button, So the system can resume normal operation. One Key Top Up 1. First use the pause button in the APP or controller to pause the refill function. 2. Take out the old water in the fish tank . Step 2 1. Search for "Smart life" in the APP market, then download and install it. 2.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.