User's Manual

Operation Instruction
I. Main Functions:
1. Six function keys: SNZ, SET, ▼.CF/WAVE,LCD and ALM..
2. 12/24 hour selectable.
3. °C/°F selectable
4. Indoor temperature range: 0℃--+50℃
5. Outdoor temperature range: -40℃ --60℃
6. Outdoor temperature with RF: up to 3 channels
7. Double alarm function
8. Snooze function, ring again after 5 minute later
9. DST function
II. Key Function:
SET
▼.CF/WAVE
SNZ ALM LCD
Click Switch display °C/°F
switchable
Backlight on On/ off alarm Switch the four
t
zone
standard mode
Hold enter into
time/alarm setting
----- ----- ----- Enter into LCD
Brightness setting
Click Confirm the
Setting
one step
backward
----- ----- -----
Time set
Hold enter into
time setting
8steps/second
backward
----- ----- -----
Click Confirm the
Setting
One step
Backward
----- ----- -----
Alarm set
Hold enter into
alarm setting
8steps/second
backward
----- ----- -----
III. Instruction of Operating
3.1 RCC singal
1. Press and hold “▼.CF/WAVE “ button for 2 seconds to receive the RC signal manually. The RC symbol is
flashing on display. If the reception is successful, the RC symbol is shown on display.
2. “DST “ is shown on display if it is in Daylight Saving Time mode.
( Note : The clock automatically scan the time signal at AM2:00, AM3:00, AM4:00 and AM5:00 ).
3.2 Normal states
1. Click “SET” key to alarm mode.
2. Hold “SET” key to enter into setting mode
3. Click “▼.CF/WAVE” key to switch between °C/°F
4. Press “LCD” key to switch the time zone.
5. Hold “LCD” key for 2 seconds to adjust LCD brightness setting, total 8 levels.
6. Click “ALM” key to switch the alarm on/off
7. When alarm is ringing, click “SNZ” key once to enter into snooze state,
the alarm will ring again after 5 minutes
3.3 Time setting
1. Hold “SET” key for 2 seconds to enter into time setting
2.
The setting item will flash 1 HZ
3. The sequence of time setting: 12/24HRHourMinuteYearMonthDateDST ON/OFFExit
4. Press “SET” key to confirm the setting.
Function
Operation