User's Manual

ManualsBrandsFuzhou Rise Electronic ManualsElectronicsDigital Clock

user manual

I. Main Functions:

1. Six function keys: SET, ALARM, LCD, UP/CH, DOWN/CF, SNOOZE.

2. 12/24 hour selectable.

3. °C/°F selectable

4. Indoor temperature range: 0℃--+50℃

5. Outdoor temperature range: -20℃ --60℃

6. Double alarm function

7. Snooze function, ring again after 5 minute later

8. DST function

II. Key Function:

SET Up/CH DOWN/CF SNOOZE ALARM LCD

Click Switch display Switch RF

channel

°C/°F

switchable

Backlight on On/ off alarm -----

standard mode

Hold enter into

time setting

Clear RF data ----- ----- ----- Enter into LCD

Brightness setting

Click Confirm the

Setting

one step

forward

one step

backward

----- ----- -----

Time set

Hold enter into

time setting

8steps/second

forward

8steps/second

backward

----- ----- -----

Click Confirm the

Setting

one step

forward

One step

Backward

----- ----- -----

Alarm set

Hold enter into

time setting

8steps/second

forward

8steps/second

backward

----- ----- -----

III. Instruction of Operating

3.1 Normal states

1. Click “SET” key to alarm mode.

2. Hold “SET” key to enter into setting mode

3. Hold “UP/CH” key to clear out all data of current channel

4. Click “DOWN/CF” key to switch between °C/°F

5. Hold “LCD” key for 2 seconds to adjust LCD brightness setting, total 8 levels.

6. Click “ALM” key to switch the alarm on/off

7. When alarm is ringing, click “SNOOZE” key once to enter into snooze state,

the alarm will ring again after 5 minutes

3.2 Time setting

1. Hold “SET” key for 2 seconds to enter into time setting

The setting item will flash 1 HZ

3. The sequence of time setting: 12/24HRÆOFF/SETÆHourÆMinuteÆLanguageÆYearÆMonthÆDateÆExit

4. Press “SET” key to confirm the setting.

5. Press “UP/CH” key one time, the setting will go forward one step; hold the key for 2 seconds, it will run forward by 8

steps/second.

6. Press “DOWN/CF” key one time, the setting will go backward for one step; hold the key for 2 seconds, it will run back

by 8 steps/second.

The system will exit automatically if no key is operated in 15 seconds. And the previous setting will be

confirmed automatically

Function

Operation

Summary of content (3 pages)

PAGE 1
user manual I. Main Functions: 1. Six function keys: SET, ALARM, LCD, UP/CH, DOWN/CF, SNOOZE. 2. 12/24 hour selectable. 3. °C/°F selectable 4. Indoor temperature range: 0℃--+50℃ 5. Outdoor temperature range: -20℃ --60℃ 6. Double alarm function 7. Snooze function, ring again after 5 minute later 8. DST function II.
PAGE 2
3.3 Alarm set 1. Hold “ALM” key for 2 seconds to enter into alarm setting 2. The setting item will flash 1 HZ 3. The sequence of alarm setting: Hour Æ Minute Æ exit 4. Press “UP” key one time, the setting will go forward for one step; hold the key for 2 seconds, it will run forward by 8 steps/second. 5. Press “DOWN/CF” one time, the setting will go backward for one step; hold the key for 2 seconds, it will run back by 8 steps/second. 6.
PAGE 3
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver.