User's Manual

ManualsBrandsFuzhou Emax Electronic ManualsElectronicsKey Finder

STG-1213 Manual

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference

that may cause undesired operation.

BATTERY PRECAUTIONS

Dispose of old batteries properly. Do not dispose of old batteries.

Do not leave batteries lying around where a young child or pet could

play with or swallow them. If batteres are swallowed，contact a physician

immediately.

Batteries may explode if mistreated. Do not attempt to recharge or

disassemble batteries.

SAVE THESE INSTRUCTIONS

SMARTFIND OPERATION

Installing Batteries

Key Ring Receivers

Each key ring receiver uses one CR2032 button cell battery

(included).

1. Use a small precision screwdriver to remove the screw on the back of

the receiver. Remove the battery cover.

2. Install the supplied battery into each key ring receiver, ensuring

the '+' side of the battery is facing up.

Using the Key Ring Receiver

The SmartFind Personal Item locator has two key ring receivers.

Each receiver is color- and number-coded to match a corresponding

Summary of content (5 pages)

PAGE 1
STG-1213 Manual FCC COMPLIANCE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. BATTERY PRECAUTIONS Dispose of old batteries properly. Do not dispose of old batteries. Do not leave batteries lying around where a young child or pet could play with or swallow them.
PAGE 2
STG-1213 Manual button on the transmitter. 1.Attach keys to color-coded key ring receivers. 2. press and hold the appropriate color-coded button on the transmitter for five seconds. 3. If the key ring receiver is in range (60 feet), it emits an audible beep. 4. If no beep is heard. change your location and press and hold the color-coded button again for five seconds. Attaching the Slim Receiver The SmartFind Personal Item Locator also has two slim receivers.
PAGE 3
STG-1213 Manual 3. Replace battery cover and securely screw the cover into place. Do not overtighten the screw. Slim Receivers Each slim receiver uses one CR2032 button cell battery( included) . 1. Pull out the battery door (the colored area). 2. Install the supplied battery into each slim receiver, ensuring the "+" side of the battery is facing up. 3. Replace battery cover. Make sure it dicks into the main body. Transmitter uses 2 AAA batteries (not included). 1.
PAGE 4
STG-1213 Manual If the Key Ring Receiver/slim Receiver Does Not Respond to Transmitter The key ring receiver/slim receiver may be outside the 60-foot range. Walk to another location and press the transmitter button again. The transmitter button may not have been held for five seconds. Retry holding for five seconds. It unsuccessful, press and hold one of the other buttons on the transmitter. Batteries may be weak or drained in the transmitter or receiver. Check the batteries and replace as necessary.
PAGE 5
STG-1213 Manual FCC STATEMENT NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.