User's Manual

FHSS3-24G 2.4GHz Module User Manual.

Futaba corporation

1080 Yabutsuka Chosei-son Chosei-gun

Chiba 299-4395 JAPAN

1. Features

 2.4GHz Frequency Hopping Spread Spectrum (FHSS) radio transceiver module.

 Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band

 Fully integrated power regulation with a wide input unregulated operating range

4.0 to 7.2V.

 Equipped Fully integrated local oscillator and 26MHz 20ppm reference crystal

 100mA operating current

 Transmit power 60mW EIRP

 Receive sensitivity up to -98dBm

 FHSS data rates up to 500kbps

 1/2 mile operating range

2. Pin assign

Pin Number

Name Description

J110 1

Vcc Module power input

GND Module Ground

DATA Input/output 1

CS Input/output 2

3. Specifications

Parameter Value Units

Storage temperature

-20 ~ +80 Degrees Celsius

Operating temperature

-10 ~ +45 Degrees Celsius

Transmit power (conducted) 16 max dBm

Receive Sensitivity -98 dBm

Input voltage 4.0 ~ 7.2 Volt

Regurated voltage 3.3 Volt

Transmit current 100 max mA

PAGE 1
FHSS3-24G 2.4GHz Module User Manual. Futaba corporation 1080 Yabutsuka Chosei-son Chosei-gun Chiba 299-4395 JAPAN 1. Features 2.4GHz Frequency Hopping Spread Spectrum (FHSS) radio transceiver module. Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band Fully integrated power regulation with a wide input unregulated operating range 4.0 to 7.2V.
PAGE 2
4. Module User Requirements 4.1 This module must be integrated into a device where the user cannot access the antenna connector and should not be able to remove or install the module. 4.2 Under a 2.14dBi antenna can be used with this module. The antenna must not exceed the gain and pattern of the standard dipole antenna. 4.3 The device must contain the following permanent labeling on the exterior of the device as follows: Contains FCC ID: AZPFHSS3-24G 4.