Instruction Manual

ManualsBrandsFUSION SPORT ManualsElectronicsSmartspeed PRO V3

Table Of Contents

Smartspeed PRO

Overview

HOW DOES IT WORK?

Each Smartspeed PRO gate contains an in-built radio device for wireless communication with a

SmartHUB through IEEE 802.15.4.

You will set up your SmartHUB unit, which will connect via Bluetooth to your mobile device. This will

then command your PRO gates during the session.

It is very important that you always place your SmartHUB close to where you will be standing to run

the session, as the range of the Bluetooth connection is between 10 – 20m (depending on your

device).

Once you set up and align your PRO units, a beam will be created between the timing unit and the

reflector. We call this a timing gate. When someone passes through this beam, we say that the gate

has been broken. The first time you break the timing gate beam, the starting point (start time) will

be set and the subsequent beam breaks will then list the split times. A split time is the time between

beam breaks on one or more units.

Summary of content (4 pages)

PAGE 1
Smartspeed PRO Overview HOW DOES IT WORK? Each Smartspeed PRO gate contains an in-built radio device for wireless communication with a SmartHUB through IEEE 802.15.4. You will set up your SmartHUB unit, which will connect via Bluetooth to your mobile device. This will then command your PRO gates during the session.
PAGE 2
Usage Instructions To get started with using Smartspeed PRO, you will need the following; 1. Your PRO system 2. A supported Apple or Android device with Bluetooth enabled and an internet connection 3. A computer that is connected to the internet 1. DOWNLOAD THE SMARTSPEED APPLICATION Download the Smartspeed app by visiting either the iOS app store if you are using an Apple device, or Google Play store for an android device. 2.
PAGE 3
15. Adjust the beam until the red alignment light on the back of the unit is on. This can be done by aiming the photocell and directional laser at the centre of the reflector. Once aligned, the laser will stay illuminated for an additional 5 seconds before turning off. 16. In windy environments, ensure the unit is remains aligned when wobbling the unit slightly side to side. 6. RUN YOUR SESSION 17. Press Start on the home screen and proceed to the Session Set Up screen. 18.
PAGE 4
Compliance FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.