How-To Guide

2. INITIAL SETUP
16
Turn on the antenna unit and FURUNO Multi Function Display. Initial setup for this an-
tenna must be done on the FURUNO Multi Function Display.
2.1 Initial Setup for TZT9/TZT14/TZTBB
1. Press the Home key (or tap the Home icon).
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Radar].
4. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If the antenna unit is connect-
ed but does not appear in the [Ra-
dar Source] list, close the list and
open it again. The name of the an-
tenna unit should appear with a
check mark, as in the example to
the right.
5. Drag the [Menu Radar] sub menus
to find the menu item [Radar Initial
Setup].
6. Set the items referring to the table shown below
Menu Radar (Radar Initial Setup)
Menu item Description
[Antenna Rotation] Select the antenna rotation speed.
[Antenna Heading Align] See "How to align the antenna heading" on page 17.
[Main Bang Suppression] If main bang appears at the screen center, slide the circle
icon, while watching the radar echo on the left-side of the
display, until the main bang disappears.
RDxxxxxx - DR
S
6A-NX
T
RDxxxxxx - DR
S6
A-NX
T
Display example
Title