User's Manual

ManualsBrandsFurrion ManualsElectronicsEntertainment System

Table Of Contents

Specification

GENERAL

Supply Voltage DC 12V

Current Consumption Max.5A

Power Output 2x 20 W

Number of channels 2 STEREO channels.

Unit Dimensions (L X W X H): 130X 113 X 86 (mm)

FM SECTION

Frequency range 87.5Mhz - 108Mhz (Europe)

87.5 Mhz - 107.9Mhz (U.S.A.)

87.5 Mhz - 108Mhz (Australia)

Effective sensitivity 3uV.

I.F Frequency 10.7MHz.

AM SECTION

Frequency range 522Khz - 1620Khz

(Europe)

530khz - 1710Khz

(U.S.A.)

522 Khz - 1710Khz (Australia)

Effective sensitivity 40dB.

I.F Frequency 450KHz

Preamp Output 1 V Output

USB PLAYBACK

System MP3 audio system.

<=5

Frequency characteristics 20Hz -100Hz dB

<=5

10KHz-20KHz dB.

Signal to noise (USB) 50dB [1KHz] .

Wiring Diagram

R R R

L L L

HDMI JACK

ANTENNA

WIRING CONNECTING SOCKET

IR REMOTE JACK

AUDIO IN

AV IN

AV OUT

SUBWOOFER OUT

WALLMOUNT Entertainment System

Summary of content (5 pages)

PAGE 1
Wiring Diagram AV OUT AV IN SUBWOOFER OUT IR REMOTE JACK HDMI JACK R R R L L L AUDIO IN ANTENNA WIRING CONNECTING SOCKET Specification GENERAL Supply Voltage Current Consumption Power Output Number of channels Unit Dimensions FM SECTION Frequency range Effective sensitivity I.F Frequency AM SECTION Frequency range Effective sensitivity I.F Frequency Preamp Output USB PLAYBACK System Frequency characteristics Signal to noise (USB) DC 12V Max.5A 2x 20 W 2 STEREO channels.
PAGE 2
Locations and Names of the Controls 6 5 7 Wiring connecting socket view GREY 10 9 8 1 3 5 2 4 6 GREY/BLACK YELLOW +12V DC MEMORY B+ BLACK POWER GROUND Mounting Installation 4 11 3 12 2 1 15 16 14 17 13 18 Location * Choose a mounting location away from humid areas, water sources, appliances or any equipment that can radiate heat.
PAGE 3
Common operation: After the device has been paired successfully and Wall mount Stereo screen displays BT LINK, Dial with mobile phone directly. 1. To turn the unit on/off . When the unit is power Off, it may be switched On by pressing POWER button. When the unit is switched On, press and hold POWER button for more than 1 second to switch the power off. 5. Accept/ Reject/ End A) During ringing, press TEL button to accept the call. B) During ringing, press HANG UP button to reject the call.
PAGE 4
2)set the ALARM time Press and hold the 6 button repeatedly to ALARM time setting mode(the LCD will display the time “AM 00'00 “ but not flash), then use the / button to set the MINUTE and VOLUME +/- button to set the HOUR. 9. To reset unit 1,Press RESET with a cuspidal object to make the unit be reset to factory default and re-instate the correct functions. 2, In AUX mode, Press and hold 2/STOP button until the LCD displays “RESET III, then press and hold 3/RPT button to reset to the factory default.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.