ASSEMBLY INSTRUCTIONS VERSION # 20-06-03 TOOLS REQUIRED am Phillips Screwdriver (Not Included) od Phe, 2 People Recommended 00:00 EASY DIFFICULT The Assembly Rating is a 5-point system showing the level of effort needed to assemble a specific product.
CHECK BEFORE STARTING Are you missing anything? Double-check all parts, hardware and accessories listed on Page 6 are accounted for. Should we send any replacements? Are there any irregularities or flaws in the parts? We can send replacements! Check out our Quick Tips! We recommend reviewing the per-assembly handouts. Even experts need a refresher now and then! Prep Time! Please review the assembly instructions and all diagrams prior to assembling.
PRE ASSEMBLY INTRODUCTION We understand building ready-to-assemble furniture can be a challenging experience for some. To help avoid confusion, we have provided same helpful tips that may speed up the process. PUSS Teamwork ALWAYS have at least two people to help with transporting and assembling the product to avoid potential injury and/or damage. Suitable Location Assembling near the area of the intended location is highly recommended.
ASSEMBLY AND CARE ADVICE A FAILURE TO FOLLOW THE GUIDELINES BELOW MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. Tum clockwise to tighten and only tighten when step is completed or when instructed to do so. Position each part correctly and insert screws or bolts into their respective holes. Use the appropriate hand tools ar power tools for assembly. Select steps, such as tightening screws and/or bolts, may require hand tools to avoid causing damage during assembly.
WALL SHELF + Please keep instructions for future reference. « Check the quantity and irregularity of parts and hardware before you start.
ASSEMBLY INSTRUCTIONS 3 Front 0 Top Patricia € Part B PCs Please ensure threaded cylinders (4E) are popping out an each ends of panel {#A) by approximately 0.4 inches sa there is enough threading on each ends of panel (#A) to secure poles.
ASSEMBLY INSTRUCTIONS 5 Front 0 | Particular «LL Part @ PCs [ 1 e Please ensure threaded cylinders (4E) are popping out an each ends of panel {#A) by approximately 0.4 inches sa there is enough threading on each ends of panel (#A) to secure poles.
ASSEMBLY INSTRUCTIONS / Front Part @ x1PC Part @ PCs Please ensure threaded cylinders (#E) are popping out on each ends of panel {#A) by approximately 0.4 inches so there is enough threading on each ends of 8 panel (#4) to secure poles Please ensure that the wail mount prate are facing the same direction as shown in the diagram.
ASSEMBLY INSTRUCTIONS Top Align the product to the wall, then mark the wall with a pencil according to haw you want to orient the product. 10 Use power drill (not included) to dri holes onto the marks on the wall.
ASSEMBLY INSTRUCTIONS 11 i. Accessory (A1) tsetses ’ Ea Top WALL Secure unit ants the wall by using screws ensure that the unit is properly aligned to the wall. Refer to page 13 on Walt Li mounting guide. X16 ) Each Shelf A EY men 1 | isu lbs @ Keep this handy! Please retain this instruction manual and any order-reflated information for future reference. @ Lift, don’t drag! To avoid damage to product please always LIFT the product when transporting of adjusting the placement.
ASSEMBLY INSTRUCTIONS Wall Mounting and Fixing EXPANSION WALL ANCHOR Our provided expansion wall anchors are only suitable for masonry walls, such as drywall, plaster or concrete, and are best for holding lightweight items or for anti-tip prevention. If you are unsure of the correct wall anchor to use with the product, please request professional guidance. liability for product damage or failure due to using the incorrect anchors will fall on the installer.