Instructions / Assembly

Installation Instructions
Tools Needed:
-
Pencil
-
Wrench
-
Screwdriver
-
Drill & Bits
-
Silicone Sealant
Concrete Vessel Sink Installation Manual
Parts Needed:
-
Faucet
-
Drain Assembly
-
Supply Pipe & Fittings
-
Drain Pipe
-
Trap & Fittings
1. Planning the Layout.
If there are no pre-drilled faucet holes, decide where you want the faucet to be in relation to the
sink. Once you've decided on a vessel sink/faucet layout, make a template of the counter top
(cardboard will work best for your template). Then, mark the appropriate location for the sink
drainage ano d faucet holes. Draw everything out and make any necessary changes prior to
drilling g and cutting.
2. Making the Cuts.
After you've created and marked your template lay it out over the counter top and
make the necessary marks directly onto the counter top.The best way to do this is to cut out your
final marks on your template so you can draw directly onto the vanity. After you’ve marked the
vanity top, make the necessary cuts.Once the cuts have been made, take your sink and faucet and
place them onto the vanity to make sure every- thing lines up. Make any necessary alterations to
your cuts until everything lines up perfectly.
3. Seal the Sink.
Position the sink,then seal and tighten everything down