User Manual Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure).
The following information must be indicated on the host device of this module; [for FCC] Contains FCC ID: 2AU3BU9W34 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The following statements must be described on the user manual of the host device of this module; [for FCC] FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
for indoor use only (5150-5250MHz) Pour usage intérieur seulement (5150-5250MHz) This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules. To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations.
La transmission des données est toujours initiée par le logiciel, puis les données sont transmises par l'intermédiaire du MAC, par la bande de base numérique et analogique et, enfin, à la puce RF. Plusieurs paquets spéciaux sont initiés par le MAC. Ce sont les seuls moyens pour qu'une partie de la bande de base numérique active l'émetteur RF, puis désactive celui-ci à la fin du paquet. En conséquence, l'émetteur reste uniquement activé lors de la transmission d'un des paquets susmentionnés.
Compliance with KDB996369 D03 OEM Manual 1. List of applicable FCC rules WiFi 2412-2462MHz FCC Part 15.247 Max output power 15.92dBm WiFi 5180-5240MHz; 5745-5825MHz FCC Part 15.407 Max output power 13.65dBm 2. Summarize the specific operational use conditions When use this modular transmitter, please do not change the antenna and antenna gain, the power setting and country code can not be changed. The Antenna type is monopole antenna and 2T2R 2400-2483.5MHz Peak Gain: ANT A: 2.55dBi; ANT B: 0.
9.